Hi Gentlemen and ladies,
Problem I am experiencing is there is little pressure in my brake
system making it difficult to bleed the brakes, and of course, no
brakes.

1995 Pontiac Trans Am
LT-4 GM Performance parts crate motor, dealer installed ($7800)
112k on car  ~75k on motor
Leaks nothing, no problems, everthing works.

looking for a set of alumnium heads for a 383 running 10:1 with KB
hyperutectic pistons and an eldelbrock rpm manifold dual
plane..looking for low end torque.. flow numbers look good for
canfield..exaust not so good..is 180cc to small for a 383.. should I

I found this in a news group and decided to try it. A little while
back, I was browsing through
news groups, just like you are now and came across a message just like
this, that said you

Is there any suggested way to change the left side spark plugs in my z28?
It looks like the right side are reasonable, but the left side ...
Do you have to do it from the bottom of the car?
Any special tools required?

Hello guys I have a set of Camel Hump heads and they are about 100 miles
away from me right now and I would like to know what is the Weight of them?
with valves,springs and retainers.
thanks a Ton

Left and right side lower front (between wheel well and door opening)
quarter patch panels for sale for a 67 or 68 Camaro or Firebird. These
parts are brand new I just decided to go with full quarters. I also
have brand new full floor pans left and right for sale which will fit

Hello Guys and Gals
I have a 1967 camaro with a factory center console. I converted the Slip and
Slide to a Th350. The problem that I am having is that the factory shifter
is pretty sloppy and worn. I would like to get a new one however no one