I have a 95 Camaro. I just notice my speed and tac gages or jumping. My
other gages or normal. Looks like a electrical problem. Has anyone else
seen this happen before?

My 67 Camaro has had a horrible exhaust stink for awhile now.  It's bad
enough that just starting it up and pulling it out of the garage is enough
to make you sick to your stomach, make your eyes water, and stink up your
clothes until they're washed again.  It's so strong that my ...

If you have something to sell, such as a car, computer, furniture or
anything else for that matter, go to www.inmynest.com and post a listing in
your home state or city. All ads are placed FREE of charge!

I need some Help. I have a 95 Chev Camaro. The switch for the high and low
beams for the heads don;t work anymore. Is this part of the turn signal
switch and wiper on and off switch? I have a part that I purchase online
ACDelco# 26035242 but I'm not sure it's the right parts. Does ...

Hi…I was hoping to get some opinions from you all when it comes to
Muncie transmissions and rear end gear ratios.   I am building a 67 RS
Camaro to take to cruise nights and drive around town on the weekends.
I am putting in a big block with a Muncie M21.  I was told that the

1973 Chevy Corvette, great condition. L82 high perfomance motor, M22
"rockcrusher" transmission, 4.11 Differential, Long Tube Headers, Custom
Exhaust, Edelbrock Intake, 4 bolt main, forged steel crank, forged steel
rods, forged steel pistons, 2.02 "fueler" heads. Custom Pioneer ...

I need to find the serial number on the engine of my firebird and have no
idea where it is... anyone???

I'm searching the real statistic of the production of the Camaro and
Firebirds that was construct in Ste-Therese between 1986 to
september 2002.
I need the # of employees int each year, the rate of production

My problem is that I have a 87 firebird that starts but then dies.  I
checked the fuel presure at the fuel rail and it maintains 35 to 44 psi
depending on wether or not it is being cranked over.  I checked the oil
sending unit and all other components (electrical) that I know of ...

hi
can some one tell me how I change the ignition key cylinder on my 88 camaro v6 , I had to short out the start solenoid to get the engine going to get me back from work ,the key is still stuck in the cylinder I can not turn it so I can get it out and I can not turn it to start ...

I've got a 93 Trans Am, and I'm wanting to build a standard small block
Chevy to go in it. I want a standard Holley carb, and distributor. Does
anyone know what will be involved. I have Mac headers on this car. Will they
fit up with standard small block heads, or are the exhaust ...

I was on the way home today & my IROC suddenly surged & then lost all power.
The engine shut down.
I cranked her over lots of power for that, but she wouldn't fire up.After I
got her back to the garage towed of course, she fired up like it never

I need a trunk lock for my 1985 Trans Am (w/o power hatch). Can I use
the trunk lock from a 82-92 Camaro? How about the lock from a 82-92
Firebird with a power hatch?
Thanks

Can anyone point me to where I can find the ID #'s that are on a Hurst
Competition Plus shiter ?  I need a shifter for a 1967 camaro/M21
trans with a console and am going to one of New Jerseys largest car
swap meets this upcoming week.  I understand that the shifters are the

What is recommended when the ECM needs to be reprogrammed after a battery
change, should the engine be warm or cold? Is it better then to drive in the
city or an a highway?
Thanks in advance