I just joined the club although i dont have a camaro or a firebird, i
do however have a pretty racey 81 malibu hahahaha.

I am restoring a 1969 Camaro Z/28 - RS and looking for as much
information ( data, specs, etc. ) on this combo. I am not looking for
production numbers, just raw data. My car is an X33 code, Hugger
Orange with white strips and white interior. Can anyone help?

OK, I did some thinking and decided that since I'm over cutting one hole in
the floor for a TH350 shifter, I might as well go for what I really want
anyway which is a 4-speed Muncie to replace the old Powerglide.  I now have
a column-shift with the "rare" (but not desirable?) bench ...

I have a 78 Trans Am which has had a recurring issue with the charging
system.
I'll start the car and drive off, and find that the alternator is not
charging.  Voltage gauge at ~12 volts, turn signals slower than usual,

Hopefully a quick question. My alternator is screeching so I want to rebuild
with new bearings. Which alternator is on my car? I'm not sure which rebuild
kit to pick up.
1990 Trans Am GTA LB9/700R4

have been in a wheelchair for about 10 years now and i built an 81
malibu with a 406 sbc, Edelbrock RPM heads, Tunnel Ram w/2-450
Holleys, full MSD setup, cam is crane 300 dur 510 lift, with a Pete
Jackson Gear Drive, stall is

I just purchased a 1967 camaro RS with a 350 motor.  It is leaking oil
around the oil filter.  I have pulled the oil filter.  The Guy I
bought it from put RTV abound the out side housing( part of the
block).  This out side housing spins but does not come loose.  I would

I drove my car for about 3 days then it sat for about 2 days. I went
out to start it and it wouldn't start. I thought I flooded it so I let
it sit for a few. It still wouldn't start. I checked to see if I was
getting any spark and there is no spark. I felt of my fuel pump and

Hey all its another post from an '80 Z28 owner...
I recently put the car on the road, it stickered fine and drives
awesome for the most part. However, there is a few small things that
grab my attention and I wonder if anyone knows the extent of work

Looking for a shaker hood in good shape. I had mine repaired but too
much bondo used... It cracked.

How goes it all?
'99 T/A
Well it rained like hell.  I had enough clearance to get across the water until someone slammed it and threw this
"breaker" under the hood.  That was enough to stall it out.  Tried a couple times to see if it was going to crank but no