| Thread | Last Post | Replies |
|
| transmission question | 18 Nov 2005 01:43 GMT | 4 |
I have a 2000 grand am and would like to check the fluid, how do you do that in a closed system?
|
| Great Gifts For Gearheads | 17 Nov 2005 03:36 GMT | 1 |
T-shirts, mugs and other great stuff for real gearheads, honorary gearheads and would be gearheads at: http://www.cafepress.com/cribsheet
|
| Re: Larger Battery = Easier Starting? | 17 Nov 2005 03:34 GMT | 10 |
Has it occured to anybody that you should be able to start your car with a dead battery, if you have to? A safe, relatively convenient, non-electric, manual method of starting the engine is possible. Get rid of the battery-dependent computerized fuel injection, computerized
|
| Bucket seat headrest removal | 16 Nov 2005 23:23 GMT | 4 |
Does anyone know how to remove the headrest without damaging it.I want to install seat covers and then put them back on.
|
| CAN YOU swap the A/C&Heat Contol Units | 16 Nov 2005 20:40 GMT | 1 |
Wondering if there are any Pontiac mechanics out there or if any one has done this; but I would like to swap out the manual A/C & Heat Controls for the Climate Control Unit. Is this possible? How difficult of installation expected. Would the wiring hook straight up
|
| 96 Grand Am battery terminal melted | 16 Nov 2005 19:37 GMT | 4 |
My brothers' 96 Grand Am positive battery terminal melted a couple days ago. We replaced it but I see more trouble ahead. The cable looked bad to me. Do you have to replace the entire wiring harness ? He's recently replaced battery and alternator.
|
| Grand Prix Soaked passenger Rug | 16 Nov 2005 19:15 GMT | 5 |
Hi there... Purchased my daughter a 1999 Grand Prix... the passenger side rug (where your feet reside) is SOAKED... not damp... but literally a gallon or so worth of moisture. I've: 1) checked and double checked the door/window/trunk seals.
|
| No head lights | 16 Nov 2005 18:28 GMT | 1 |
My son has 1995 Grand Am V6. The park and Fog lamps come on but head lights don't. Fuse is good. It has four relays on firewall, but are not labelled. Can you tell me which one is for head-lights ??
|
| 1997 Grand Prix needs stronger springs??!! | 16 Nov 2005 16:11 GMT | 6 |
I had taken my car into a repair center recently and the service techs say I need a stronger suspension in the rear. I have never replaced anything for the suspension and apparently I'm being told my rear tires are being worn in a wavy pattern because of the extra weight from my
|
| A/C Fan | 16 Nov 2005 03:45 GMT | 1 |
I have a '98 Pontiac Bonneville SE and the A/C cooling fan is intermittent/ dead at times. Anyone have any ideas on the cause/fix?
|
| 1997 Grand Prix GT - ABS & Traction Light On/Off | 15 Nov 2005 20:03 GMT | 2 |
I recently replaced the front & rear brake pads on my 1998 Grand Prix GT. Prior to doing so, everything was fine. Upon putting on the new pads, I began to get an ABS/Traction indication. It doesn't occur all the time, but once the car has been use for a while, the ABS light comes ...
|
| How do I troublshoot a fuel gauge problem? | 15 Nov 2005 01:39 GMT | 2 |
My '99 Bonneville's fuel gauge goes crazy after I fill up the tank. Reads Full, then dances around to empty and all places in between. Until now, it would read full after letting it sit for a night. Someone suggested that might "clean" the gauge sensor/mechanism by running
|
| crank sensor | 14 Nov 2005 18:49 GMT | 1 |
can anyone tell me where the crank sensor is located at exactly on the 1992 pontiac transport,and also when i am in park mode,and put it in drive,i hear a strange noise in transmission,what should i look into,body is mint,and also what is best way to put back up overhead material ...
|
| 93 Grand Prix - brake problems | 14 Nov 2005 13:29 GMT | 1 |
I am unfamiliar with these cars, but when you press on the brakes, even slam on them, they just slowly bring the car to a stop. Dangerously slowly. Anyone had this before and have a solution? My thoughts are air in the brake lines?
|
| 2001 Pontiac Sunfire | 13 Nov 2005 12:46 GMT | 2 |
Just noticing since the weather has gotten cooler that speed 1 and 2 on my heater don't seem to be blowing. I have to turn it to the 3rd setting or higher to get heat blowing out. Does anyone know why or what the problem might be. TIA.
|