I am trying to trouble shoot a problem with the Turn signal on my Grand am,
the problem is sometimes the signals work and sometimes they don't i am
thinking it may be some kind of relay problem, any help on this subject
will be greatly appreciated.

    Just ran into this problem.  Also, I am a new poster.  1990 Pontaic
Grand Prix 2 door 3.1L w/ 314,5000 miles.  The strut bearing plates are gone
in the rear so I am trying to replace them.  Thought I would replace the
struts as well, but ran into the J37956 tool problem.

i have an 88 grand prix and need to pull the motor the motor is good the car
is junk need an easy tip
also i have a 93 that stalls all the time it throws a code for the module i
have replaced it but still does the same thing

My '96 sunfire stalls at the stopsign thaen won't start.  No engine light comes on it just dies.  After an hour or so it starts back up and runs fine.  This happens about once a week.  Any ideas???
--
DaveG
-----------------------------------------------------------------------

I am in the process of removing a defective 3.8l series 1 engine from a
1995 Ponriac Transport.  My intention is to replace it with a good 1995
Buick Lesabre 3.8l series 1 engine.  However, I need to find engine
rebuild diagrams for the Transport engine so that I can determine what

How do you get the power steering pulley out of the way to get water
pump to be replaced

    I have a 94 grand am SE. Lately i've been having lots of trouble with my
car.First the cigarette lighter wouldn't work.I changed my fuses and it
didn't help.Then it started missing (really bad where i would have to drive
it in 3rd ).I changed my spark plugs and wire.It seem to ...

I went and had an emissions done on my 1990 Grand am. i have replaced the
oxygen sensor, timing chain, fuel injectors, manifold, crankshaft sensor,
engine module, fuel filter, alternator belt and a few more things. The only
thing I haven't changed was the catalyric converter. I put ...

Have a 2000 Grand Prix GTP which all of a sudden started doing the
following:
After the vehicle is driven approximately 5 miles the ABS light and the
TCS OFF light come on at the SAME time. There are no obvious problems

I need the head bolt torque specs for '93 Grand Prix 3.1 T.
Thanks

I recently purcahsed a 2004 Grand AM SE. CarFax was clean and the car
was a a great deal. I have one question/complaint... Seems at 5mph and
above there is a pulsing hum that is coming form the car. This is not
felt, but heard. The faster I go the faster the puls becomes. It

I'm sure this has been discussed to death..
I'm in the market for a Vibe/Matrix.
I like the new styling of the Vibe, looks good!
I'm sure I'd be happy with either/or.  I hope the dealer treats me as well

How hard of a job is it to change both belts ?

Axle bearing need two, for 66 GTO 10 bolt  NOS .
Are 2.891 OD X 1.437 ID X .740 thick, these are sealed ball bearings.
Thanks , I can't find them anywhere, NAPA or any bearing places.
Used ones in good shape would be ok (in a pinch).

I had lost my keys & Keyless remote to my 1995 Bonneville, i changed the ignition switch & now i cannot start the vehicle & the security light on dash is constantly on. Does someone know how i can disarm the factory security or bypass it ?????
--
GuyNOcalaFla