Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Porsche / Porshe 944 / April 2004

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
Thinking of buying early ... UK insurance18 Apr 2004 02:33 GMT1
I am looking to trade out my restored TR6 for a 944.
Is there a significant period where insurance becomes "classic"?
The TR is only ?112 for a year so I need to prepare!
TA!
1987 944 n/a Clutch Problems17 Apr 2004 18:22 GMT4
Well, it finally happened, While the engine is idling, I cannot get the
transmission to shift into any gear with the clutch pedal pressed. I can
shut off the engine, and push the clutch pedal, and it goes into any gear.
When you start the 944 in 1st gear, pushing the clutch pedal in ...
AFN (UK dealer) URL required15 Apr 2004 16:39 GMT1
Does anyone know the URL for AFN's website? I can't find it. Tried the
obvious, and searched on Google. All the links I've found point at one of
those URL sellers who have "reserved this address" type-of-thing.
Boost enhancer for sale14 Apr 2004 11:02 GMT2
I'm going for a Guru setup with accuboost so I'm selling my 4 week old boost
enhancer for ?80.00 inclusive of postage.
Details here.
http://www.promaxmotorsport.co.uk/
Noises from the right/rear14 Apr 2004 06:52 GMT8
For a while now I've been having this clunking noise comming from the
right/rear of my 944...  When the clutch is depressed, the noise stops as
well as when I put it neutral and let it coast.
I had the wheel bearing replaced and it's still there.....  For a while I
water leaking in13 Apr 2004 02:21 GMT4
I seem to have a pretty signifigant water leak in my 944. water was
poolining behind the passenger seat today. It has been part on a bit of a
hill since it rained yesterday and I found the front carpet pad to be a
little wet as well (very front edge up under the dash) . So from the ...
end of the story, odd 944s failure12 Apr 2004 13:06 GMT1
finally chased down why my daughter's 944S was blowing fuses and damaging
the wiring harness - as you know, this car (and this car only) has a
pressure switch on the pwr steering pump that signals the DME to speed up
the idle when you are using lots of power steering power (e.g. ...
DME schematic needed 86 94411 Apr 2004 02:37 GMT2
Having problems with my 1986 944.  No spark.  Checked the easy stuff and
replaced the DME relay but no change.  After reading through some of the
other postings I believe I'm heading down the correct path but could use a
good schematic of the DME unit.  Can anyone help.  Thanks.
where can I get a 944S electrical schematic08 Apr 2004 20:43 GMT2
my Porsche service manual only covers through late 85 - any clues where I
can find a schematic for an 87 944S ?????
thanks
help - 944S PS pump pressure switch connections05 Apr 2004 20:39 GMT4
ok, I have the schematic, I have the car, but I have one unaccounted for
wire
on the 944S, there is a pressure switch on the hydraulic pump for the power
steering.  According to sheet 9 of the schematic, there is a red/green
1987 944 w/ no spark...any thoughts?04 Apr 2004 16:04 GMT1
Plain jane 944 w/ no spark from coil. Power going in to coil but none out.
While cranking, no pulsing from either side of the coil w/ a test light.
Could it be crank sensor?
Top dead center sensor? I can feel the ignition relays click while trying
944 Turbo dont start after rebuilt03 Apr 2004 02:51 GMT1
My 944 t don't start after complete overhaul. I have ignition and I have
fuelpressure. The fuel injectors have battery voltage on terminal 2 with
ignition on. Every fuel injectors have 6 ohm resistance. All 3 ground
terminals is connected to the engine. All vacuums hose are right ...
Side View Mirror02 Apr 2004 02:44 GMT2
Can anyone tell me the best way to replace the glass mirror after it
falls off. Super glue, contact cement, or what?
Severian
Pages: 1 2 March, 2004
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.