Hi, I have a vibration in the front end when breaking at higher speeds
(above 60mph). I just had the front end aligned and checked out and it's OK.
I replaced the front pads and rotor about 3 months ago. I bought the cross
drilled rotors. Installed new tires last month also. Any ...

I have a 1986 Porsche 944 and want to sell it. Its from florida no
rust and 90,000 miles.  Its red with black interior and has a slight
rip in the drivers seat from getting in and out. What do you think I
should sell it for$$??

I had to replace the Torque Tube on a 1978 924.  Pilot bearing tore up the
input shaft which in turn created more problems.  When replacing the tube I
had to drop the rear suspension and I had to cut the bolt that holds the
right side rear suspension up (Mounting Flange Bushing).

Sounds like my camshaft or anicilary parts might be dues for replacement.
I'm thinking "ouch" - I assume this is right!
Apparently, the play in the shaft should be 5/1000 inch - it's 1/8 inch -
so that's about 24 times too much.

I just bought a 1983 porsche 944 it was a good deal for only 1000 but
is sat under a cover for two years. i knew there was going to be some
littles problems. the first that i have ran into was that the fuse for
the fuel pump is not burnt out but it is not geeting power so no gas

The external door handles on my son-in-law’s 1988 944 do not work. He
has to either leave a window open or crawl through the hatch. The car
can be locked/unlocked just fine. The Hanyes manual really gives no
hint on what to look for.

My '86 944T won't shift into first or reverse while the engine is
running. The other forward gears seem to work fine, and all of them
shift smoothly when the engine is off. I can put the car into first or
reverse, let out the clutch, and then start it with no problem. The

Is it fair to say one can buy a LHD version somewhat cheaper than the RHD.
If so what are the drawbacks for example on insurance and resales.
Cheers.

Hi All I wonder if any one knows of a good supplier of Plug leads, rotor
button and distributer cap, in Australia or if any of your dealers export to
Aus.
Ken

I have an 86 non-turbo. I really want it to look different than everyone
elses...any idea where I can get body kits or effects?  I found a couple of
sites but nothing really that good.  I like the classic look too, but want
to experiement. Suggestions?

Ok guys.....what have I got?  I picked up a 1983 944 convertible about a
year ago and parked it in the garage and havent played with it yet.  Any
ideas if this was a conversion done at the factory or???  It looks like
a factory deal.  Anyone ever see one.   Its got carrera gt on the ...

I have a pretty small dick and I wonder if a Porsche 944 can enhance
my penis size ???

My 944 (I'm in the UK, by the way) occassionally wont start. It will run for
days perfectly, then just not fire up. Leave it a few days and it starts
fine. I've replaced the fuel relay, vaccuum pipes. Checked the coil, plugs,
distributor, there is a spark (haven't replaced them ...

944 owners in the US: How much does it cost you to fill your 944 when
it's on 'R'? Where I live, the price of gas is around $2.10 a gallon.
When I put $26.00 worth of gas in, it barely reaches a full tank...

I am about to replace the steering rack on my 87 NA 944.  I have a rebuilt
rack, new boots and new tie rod ends.  Are there any surprises in store for
me?  Looks pretty strait forward from the manual perspective but there is no
substitute for experience.  Any tips/advice will be ...