| Thread | Last Post | Replies |
|
| First Time Buyer | 20 Dec 2004 02:40 GMT | 9 |
I finally drove a SAAB today from a used car dealer. (1989 2 Door Turbo ) I must say that it handled very well and i am very interested in buying. A very intriguing car it may motivate me to start turning wrenches again. Since I have never owned a SAAB before , What should I
|
| Adding CD Changer to Saab 9-5 | 20 Dec 2004 00:17 GMT | 6 |
I am adding a CD changer to my Saab 9-5. How would I get better sound quality, by using an FM Modulator or a Tape Deck Adapter? Is there any way to bring in the audio from a non-Saab CD changer through the CD input?
|
| paging British C900 owners | 19 Dec 2004 01:46 GMT | 3 |
Does anyone over there (I am in the US) know where a salvage yard is that would have a late model C900T non catalyst car? The car would have a transmission labeled GM55804 or GM55806. I am looking for the primary gears on the front of the transmission. Does anyone know where one ...
|
| MA Independents | 18 Dec 2004 15:40 GMT | 1 |
Anyone know of a good SAAB indepedent garage near Westboro MA -please?
 Signature Richard Sutherland-Smith 19 Webb Road, Wanganui 5001,
|
| 1992 Sabb conv 2.1 check engine light | 18 Dec 2004 11:14 GMT | 1 |
Check Engine light on car still has rough idle after replacing idle control valve, oxogen sensor , fuel pressure regulator and eliminating air mass meter. Also new plugs wires, plugs, rotor and dist cap. Can not find any air leaks or fuel leaks. Any suggestions would be appreciated ...
|
| "CDC CODE" | 18 Dec 2004 03:30 GMT | 11 |
This is the message on the SID when I try to access the CD changer in the trunk. Any knowledge as to what causes this? Do I need a dealer to correct this or do I have other options? Thanks for your help
|
| Saab parts in the US | 17 Dec 2004 23:26 GMT | 4 |
I need a muffler for a 96 900S. Where in the US is a good place to buy such parts?
|
| 99 9-5 head gasket | 17 Dec 2004 02:53 GMT | 1 |
I have a 99 9-5 Saab which just started leaking oil @ 98K miles... at first I thought it was the oil filter but it isn't and appears to be above the filter... it is very hard to see where it is coming from; viewing from top bottom... any ideas would be appreciated. Thanks
|
| suspension bushings - poly or rubber? | 17 Dec 2004 01:27 GMT | 7 |
I need to replace suspension bushings and am getting mixed reactions when I talk to people about the idea of replacing the existing rubber bushings with polyurethane ones. What are your experiences with polyurethane bushings and do you recommend
|
| help finding oil leak | 16 Dec 2004 23:31 GMT | 1 |
I have a 99 9-5 Saab which just started leaking oil @ 98K miles... at first I thought it was the oil filter but it isn't and appears to be above the filter... it is very hard to see where it is coming from; viewing from top bottom... any ideas would be appreciated. Thanks
|
| headlights on engine dies | 16 Dec 2004 18:12 GMT | 3 |
I have a 91 Saab 9000 . if the engine is could , and I turn on the headlights , the engine dies . but if it warms up for five minutes . it's OK. Has anybody had this problem or know of a possible solution. Thank you in advance
|
| 9000 tensioner problem? | 15 Dec 2004 19:16 GMT | 4 |
We have just replaced the chains in my friends 1996 9000 Aero Automatic. He is now suffering from a vibration at low revs which smooths out to be unnoticable up the rev range. The chains were all adjusted to TDC and the marks on the balance shafts and cams all lined
|
| 96 9000 aero Headlights | 15 Dec 2004 12:14 GMT | 1 |
My headlights momentarily dim when the a/c comp clutch cycles on. It is real noticeable at night. Does anyone know how many amps the clutch should draw? The volts drop from 14.4 to 13.2 but I have not measured draw. I can not find amp and volt draw spec's for the comp clutch. I ...
|
| 900i is getting lower | 15 Dec 2004 04:12 GMT | 3 |
two years ago I could get the trolley jack underneath; one year ago I would only go under the supporting brace (from chassis span to front); now, it wont go under.
|
| c900 heater core bubble??? | 14 Dec 2004 22:02 GMT | 6 |
I replaced the thermostat in my '86 900, and apparently I have a bubble in the heater core. The thermostat gets to a nice termperature, but the heat isn't coming in by me. I'm not seeing the bleeder valve I expected to see up in that area on or near the firewall, does someone have ...
|