| Thread | Last Post | Replies |
|
| [Saab_c900] removing early-'H' engine coolant drain plug - use a 36 mm socket! | 30 Sep 2006 13:03 GMT | 3 |
---------- Forwarded message ---------- Date: Wed, 27 Sep 2006 20:36:24 +1000 (EST) From: Craig's Saab C900 Site <c900@lios.apana.org.au> To: Saab C900 Owner/Enthusist Mailing List <saab_c900@lios.apana.org.au>
|
| replacing Crank Position sensor | 29 Sep 2006 14:43 GMT | 1 |
A few weeks ago I bought a 1993 SAAB 9000 CDE, non-turbo, I got a good deal because the previous owner said the engine dies when you run it for more than about 20 minutes at normal engine temperature. He was told by a mechanic that it is a crank position sensor malfunction.
|
| location of CV boot 93 9000CSET | 28 Sep 2006 20:01 GMT | 1 |
I want to check the condition of the CV boot on my 93 9000CSET. I jacked up the front drivers side and looked inside the front wheel well from the top. I just want to make sure I'm looking at the right boot (is there more than one boot in that location?). Does that sound like the ...
|
| TV advert worry | 28 Sep 2006 18:48 GMT | 6 |
A new TV advert claims that Saabs stay glued to the road. So how am I supposed to drive it?
|
| 2002 9-3 headlight adjustment | 28 Sep 2006 14:40 GMT | 2 |
Does anyone know how to make a vertical adjustment / alignment on the headlights? Each light has a large plastic post on the back, but these appear to be for horizontal adjustment, and I'm darned if I can find anything that looks like the equivalent for vertical adjustment.
|
| Saab 9000 v6 | 28 Sep 2006 14:32 GMT | 6 |
Can you help, My timing belt seems to have slipped a tooth, whilst driving there was smoke and clutch burning smell comming from cam belt cover, engine now runs rough, is there a nylon bush that wears causing this prob? and how do i go about replacing it, i presume the drive belt ...
|
| Gear Grinding | 28 Sep 2006 05:04 GMT | 9 |
My ethereal bliss over my recently purchased 97 9000 is tainted by one concern: The gears grind when putting it in reverse, and occasionally in 3rd. Putting it in first before pulling back to reverse eliminates that problem, but I'm concerned about the infrequent 3rd gear
|
| '94 900S - How to tell if my rear axle is bent? | 27 Sep 2006 19:59 GMT | 2 |
How can I tell if my rear axle is bent? Thanks, -- Don
|
| How to jack up a saab convertible | 27 Sep 2006 06:19 GMT | 2 |
I found the jack, but I'm not sure how to use it. Is there another piece that screws onto it? If so, what does it look like? Thanks for any help.
|
| 1992 saab conv 2.1 | 25 Sep 2006 12:05 GMT | 1 |
I Am Having trouble adjusting the linkage that controls the shifting on my automatic tran. I know the where and how to adjust but I cant seem to get it so it doesnt slip in first gear when cold. Once it warms 5miles or so it shifts flawless until next morning. There is also a ...
|
| Emissions & DIC | 25 Sep 2006 01:15 GMT | 6 |
Hello All. Our '97 900SE failed it's emissions inspection; specifically, the code for a faulty cam-shaft sensor was read (gas cap passed and ppm NOX passed). After the local independent Saab specialist re-set the codes/computers, the Check Engine light stayed "off" for about 20 ...
|
| engine swap 9000 | 24 Sep 2006 14:29 GMT | 10 |
just after some help ive got a 95 saab griffin 9000 3.0i v6. I want to put the engine in my 92 saab 9000 2 ltr lpt turbo, has anyone tried this. Is the gear box the same as they are both autos, i presume i will also have to change the engine management board (or may be not). The v6 ...
|
| Saab 900 classic brake light switch | 23 Sep 2006 20:13 GMT | 3 |
My son has a '89 Saab 900. Early this year I replaced the brake light switch. The faulty switch was sometimes sticking ON causing the battery to run down when parked. The replacement was a new switch from eeuroparts.com. Now months later, my son reported that the brake light was ...
|
| exh light 1985 900s | 23 Sep 2006 13:17 GMT | 4 |
my exhaust light has been on for awhile now. manuel states light comes on every 30k miles as a reminder. And it does not indicate a failure. I did replace a pipe awhile back. (piece just ahead of muffler) is this light going to go out by itself?
|
| '94 900S Rear wheels not verticle | 22 Sep 2006 17:43 GMT | 13 |
My '94 900S has rear wheels that are not verticle. In fact, the tires are worn down the the steel on the inside and the outside edges are almost like-new. Is this a common problem?
|