From my e-mail:
Do you know where of any studebakers that can be restored or are
restored in western Canada.  if you do not do you know where could I
find the car I am looking for.

   The under hood pictures make me wonder if it has some unknown
electrical power source, I won't pay the 10K to find out though. <g>
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=4557730590

What a crock.....
Today, Michelin told all the Michelin equipped teams that they should pull
out of the Indy F1 race 'because the tires were unsafe'..  at 5am....
And Michelin said it would not send more tires that 'were safe'...

This was addressed from bill@bondobilly.com
                              to
bill@bondobilly.com
I am wondering if somebody got control

First I would like to thank you for the comments and suggestions about my
problem.  JP was right on my having to run a compression check, #7
cylinder had only 20LBS of pressure.  I pulled the engine and found that
the compression ring had split in two. In some ways that was a good ...

Welcome to  Saskatchewan !! Thank you for visiting our beautiful province.
Here are a few things you ought to know to make your stay more pleasant:
1. That slope-shouldered farm boy you are snickering at did more work before
breakfast than you will do all week at the gym.

warning: not dialup friendly
http://www.dgtalpimp.com/m3_gtr_nurburgring.wmv
if you can drive like a normal person after watching this, you're a
better man than I...

on anouther NG there was a comment about a Studebaker building in
Detroit burning, anyone hear of this?

I'm looking for a good source for rechargeable CR-V3 batteries and a bulk
battery charger.  My new camera should be here this week and I've been
looking for a good cheap battery source.  This camera eats battery!  With
the camera and the camera power pack not including the flash ...

It's getting hot here in So Cal - actually, I could use 2.....

I was just informed that the Hawks had
two different leaf springs in the rear.
On the right side, it should have one
more leaf than the left to counter the

Anybody but me have a frustrating time getting everything to line up?  I
have learned a whole new vocabluary trying to seat this stuff and wound up
taking the sissors to it.  Thought about putting the old stuff back since
it fit.  What is it with repro stuff anyway?  Don't they ...

There's got to be a way to figure out which wire goes to what, without
resorting to trial & error, I'm hoping.  I installed a newer t/s assembly
in the column of my '55 and now that I'm reconnecting things, have found
the 6 wires from the column (red, green, brown, black & two ...

I just heard this evening that Gord Cantley, past president and
stalwart member of the Foothills Chapter of SDC passed away yesterday
evening. I believe the cause of death was lung cancer; at any rate, I
know that he had been fighting that disease for some time. Gord was

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=6466&item=4557
686999
First project is even getting them out of where they are.  The "Lark" is a
Cruiser- might have some potential.
Paul Johnson