| Thread | Last Post | Replies |
|
| Wax-on-wax-off | 13 Jul 2006 02:07 GMT | 17 |
...I bought one of those '07 v6 SE Camry's and I'm lov'n it. It has excelent acceleration, it's quiet, handles well and the technology advances over my '93 v6 Camry (254K miles) are impressive. I'm just wondering how long you folks think I should wait before I put on
|
| Pulls to the Right under acceleration | 12 Jul 2006 23:38 GMT | 1 |
I have a '82 Camry with 206K miles on it. Been a good car except that a couple of months ago it started pulling to the right a lot. I have new tires, balanced and had the front end aligned and it still pulls to the right. I normally do all my own mechanic work, but haven't done
|
| Which coating is best for Camry paint? | 12 Jul 2006 17:57 GMT | 4 |
I have a 2002 Camry, Black finish. Which type of car wax or coating, (since some are actually polymer plastics, right?) is best for the kind of paint used on the Camry?
|
| sludge on a 2001 V6 Camry? | 12 Jul 2006 05:02 GMT | 33 |
Hi, we just bought a used 2001 XLE V6 Carmy and I was dumb enough not to do enough research on it until I actually bought it. Anyway, everything is great with this car that we bought with 43,000km on it and I have the complete service records including the oil changes.
|
| Aux input Toyota Camry 2000 receiver | 12 Jul 2006 03:22 GMT | 4 |
I have a 2000 Toyota Camery CE with a factory standard CD receiver. I would like to be able to hook up my MP3 player to it, but it does not have an aux-input (3.5 mm). I have checked a local car-audio place and they wanted $250 for this ($150 parts + $100 labor)!
|
| 1994 Camry window regulator | 11 Jul 2006 15:37 GMT | 5 |
1994 Camry 2 door: Driver side window regulator has come apart. Motor still works. Can they be repaired or does one have to buy another? Will a 4 door
|
| Pulls to the Right under Acceleration | 11 Jul 2006 07:41 GMT | 4 |
I have a '82 Camry with 206K miles on it. Been a good car except that a couple of months ago it started pulling to the right a lot. I have new tires, balanced and had the front end aligned and it still pulls to the right. I normally do all my own mechanic work, but haven't done
|
| How bad is it to run with only four lug nuts on a wheel? | 11 Jul 2006 07:11 GMT | 8 |
I just found out I only have four on my left rear wheel. There's a stub of the stud remaining though the threads are in bad shape. If I can chase them I'll get a thinner nut on that. I suspect the studs aren't replacable and I'd have to go with a whole hub.
|
| new camry 2007 | 11 Jul 2006 07:02 GMT | 3 |
|
| Pre-trip check and maintenance | 11 Jul 2006 01:24 GMT | 1 |
Have a 2002 Camry 4cyl pretty fully equipped. Planning a cross country trip including hot desert, cold mountain tops, and everything in between. A few legs of trip will probably be around 10+ hours actual driving time in
|
| unknown bolt | 10 Jul 2006 23:49 GMT | 1 |
Yesterday while looking to make sure I got the dirt and grime on my car after washing I noticed on the rear drivers side underneath there was a lose bolt hanging down from the from the the car (2003 camery) I looks like there was a washer and a nut there at one time and I figure
|
| 2003 Camry rear brake plate "needs adjusting" | 09 Jul 2006 01:49 GMT | 2 |
Looking for information or your experiences: There is a fairly loud metal squeaking noise each time I take my foot off the brake (driving, parked, engine off - doesn't matter). The dealer said the "rear brake plate needs adjusting (not covered under warranty) and the problem does
|
| Locking lug nut | 08 Jul 2006 17:32 GMT | 2 |
I almost feel foolish asking what is probably an obvious set of questions. I have a 2002 Camry, but I'm sure this could apply to almost any year. Each wheel on my car has one key-locked lug nut. These locks were sold by the Toyota dealer at the time of original purchase
|
| Replacing Hood? | 08 Jul 2006 17:27 GMT | 1 |
Rookie question. Got in an accident & need to replace hood on a 95. How difficult would it be to get one from a junkyard & swap with the original?
|
| COMPRESSURE SHORT CYCLES- BUT COOLS GOOD | 08 Jul 2006 17:18 GMT | 2 |
I need help. Have a 97 Camry. Cools fine even when its 110 deg. But the compressor cycles on nd off about every 20 to 30 sec. I added freon, reduced freon. I always cools the same. Cycles off at 25 psi. High pre is good,
|