Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Toyota / Camry / August 2006

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
glove box 99 camry21 Aug 2006 23:11 GMT2
I downloaded as much as i could find from service manual concerning
glove box removal.
All diagrams show 5 screws.
I can't find bottom 2 screws.
INTAKE AIR RESONATOR21 Aug 2006 14:39 GMT1
What is INTAKE AIR RESONATOR
and what is it used for ?
http://www.turboninjas.com/camry/bo.pdf
Page BO-12
A/C Amplifier - how to get access21 Aug 2006 04:37 GMT10
Hi, I would like to check signals coming
to/from the A/C amplifier in my 1995 camry
and I have no idea how to get to it...
I know it is on the passenger side but where?
car cannot start21 Aug 2006 02:15 GMT1
99 camry ce.
I parked my car in the parking lot for three days and today I couldnot
start it. When I turned to "On", the light in the car didn't come on,
and I even couldn't use power window and couldn't lock the four doors
Camry as canoe carrier20 Aug 2006 23:30 GMT5
I'm looking to start using my '92 Camry 4 door to carry my canoe as it
uses less gas than my truck. I suppose I'll just get some foam pads as
they are cheap unless I can find a permenantly mountable bar. Anybody
have a suggestion?
lazy brake fluid change?20 Aug 2006 19:18 GMT8
Car ('96 Camry 4-cyl.) needs a brake fluid change.  I was wondering,
would it be advisable to change the fluid by sucking it out (with the
ever-useful turkey baster) from the brake fluid reservoir, and
replacing with new fluid (is it DOT-3?), once a week or so?  Would the
how to remove glove box 99 camry20 Aug 2006 06:24 GMT7
as per my other post, i am looking for heater fan resistor.  i located
a plastic panel above passengers feet.
it is about 12 in x 8 in.
it snapped out ok.
engine hesitation on startup ('99 camry)19 Aug 2006 07:00 GMT4
'99 camry, 4-cylinder, 70k miles:
Sometimes (maybe once a week) when starting the engine, after it's
already warm (for example, in a parking lot, coming back from a quick
trip to a store) the engine will hover right around 200 rpm (or less).
1995 R134a air-condition malfunction19 Aug 2006 02:41 GMT10
have my camry air-condition compressor shutting off
itself occasionally. Then turning itself back on...
Probably due to some shut-off switch - the lamp on
the a/c button blinks. Is there a way to tell which
radiator hoses17 Aug 2006 14:22 GMT12
All,
I'm trying to figure out what parts I need to replace my radiator hoses
on my '96 camry.  I  know I'll need the upper and lower hoses, and the
heater core hoses.  Here's what I'm looking at:
Rough idle16 Aug 2006 22:20 GMT4
My 97 camry 860000 miles.
When i sit at a red light i feel a little vibration when my hand is on the
steering wheel
But when i drive the car runs smooth.
Coolant leak in my 94 Camry16 Aug 2006 18:49 GMT6
Yesterday morning I discovered some smoke coming from under the hood
after I parked my 94 Camry (95K) at work. i noticed that a lot of
coolant had leaked and had collected under the two fans. i dont know
how it got there but it smelled bad.
Add money to your Paypal account with OPRAH Y[ h(15 Aug 2006 23:58 GMT1
Read this message until the end, and you will find out how the money flows in easy !!!!.
Follow the steps and it WILL work. Trust me !!!!!.
It's NOT illegal and it is NOT a scam !!!!!.
PROVEN ON OPRAH!  Reported in the Wall Street Journal!!!!
seals to replace when changing timing belt?15 Aug 2006 16:21 GMT3
Besides the water pump, what other items (seals) can/should be replaced
when changing the timing belt?
Please provide the part numbers too, so I'll know what they look like
(and know how to order them, too).
boot around sparkplug15 Aug 2006 15:37 GMT3
boot is caught around sparkplug,  when i pull out ignition wire boot is left
down inside, has anyone had this problem, how do you get it out
Pages: 1 2 3 4 5 6 7 8 July, 2006
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.