This is intended as a warning to anyone who has installed the Monroe
Quick Struts on a 97' to 01' Camry. I found out by accident that the
published spec for bolt torque on the front strut upper bearing plate
is way too high. Monroe lists on the included install sheet 59 FtLbs.

How to connect your mp3 player tot the radio (2004 V6 full map navigation)?

How soft is your "feeling on the brake"? 2004 V6 The pedal almost hit the
floor. If the engine is turned off, the pedal holds high and feels like
"solid as a rock".

Hi Camry Forum,
I have a bizar problem where no one seems to be able to solve.  We put
a new engine into a Camry 1994 Automatic  wide body.  When the car is
moving and revved at 2200rpm a significant vibration is felt in the

My 1995 Camry-4cyl- will crank but won't start. It began a couple of
months ago when it began stalling at stop signs, etc.. I changed the
IAC VALVE, COOLANT TEMP SENSOR, and VSV VALVE  but it began stalling
again and now it won't start. It ran fine before it stalled and it

I have a 2000 Toyota Camry XLE.  Today, I started having problems with
the lock system.  This is the first time I have experienced this.
When I would press on the keyless pad to lock, or unlock the doors, I
could not hear any beep sound, that normally happens.  The doors would

I have a year 2000 Camry.  I have only one key to it.  Should I
have an extra key made?  Do people usually keep an extra key to
their car?  And where to get one made?  Thanks.

i have a 2007 camry LE that makes this obnoxious "you're so special"
purchase reinforcement sound when the doors are locked or unlocked via
the remote control on the key.  i have a 2007 sequoia that came with
directions for how to shut that sound down, but the camry manual only

have received a fault code of
P0420 catalyst system efficeincy below threshold bank #1
anyone know how to correct this or what part to change

OK. Did my plugs, wires etc back in January. Car was running OK, passed
Fed emissions with high NOx. Decided to check the timing. Shorted E1&T and
hit it with the light. It was way advanced, so I reset the timing to
10DBTDC just like the manual says. Removed the jumper from E1-T and ...

I went to stop&shop this afternoon. When I came out, I couldn't start
the engine. Looks like the battery is gone, but I didn't notice any
sign at all before. I called AAA and they jump started my car. The
battery electrolyte level is a little bit lower than the minimum

How can I check to see if burglar alarm is working on 2004 Camry ?

Is removing the front door panel to get to the speakers a big deal on
the 1999 Camry?  I have power windows - I've read that I have to pry
the window switch panel up to get to a screw underneath and the other
screws are pretty obvious, besides the one under the inner door

Do you really need to drain the coolant to replace the thermostat? How much
will be lost?
I got a PO128 troubleshooting error.  The fluid level is fine. What are the
chances that it's the thermostat and not the ECT sensor?

I HAVE A COUPLE OF PROBS. I HAVE A 1994 TOYOTA CAMRY, 1ST I HAVE A PROBLEM
WITH THE TURN SIGNALS . IF IT BLINKS IT EITHER STOPS AFTER TWO BLINKS AND
THEN STOPS. ALSO THE HAZZARD LIGHT BLINKS WHEN PRESSED AND THEN STOPS. IS
THERE ANY FUSE I NEED TO CHANGE AND IF SO COULD U TELL ME ...