| Thread | Last Post | Replies |
|
| toyota park pilot sensor | 23 Jun 2007 20:49 GMT | 2 |
I would like to hear from anyone who has had this system installed on their 2007 car and your thoughts on wether its worth the money. About $500 C$ where I'm at. rq
|
| air conditioning | 21 Jun 2007 23:03 GMT | 5 |
The air conditioning on my 92 Camry no longer seems to work. I'd appreciate any feedback on what could be wrong and the cost to fix it. Thanks
|
| Owner manual | 21 Jun 2007 14:05 GMT | 1 |
Hey guys... Any hint on where to download the toyota camry 1998 owner manual... My car did not come with one....
|
| Amsoil | 21 Jun 2007 04:52 GMT | 5 |
Does anyone use Amsoil products in their Camry's? I have a 2002 LE and have been using Amsoil since about 8000km (currently at 90,000km). I was using the SDF10 filter until they changed it to a EaO10 part #. The EaO10 leaks like a sieve. I mean a nice puddle under the car. I have ...
|
| 1997 Camry | 19 Jun 2007 21:09 GMT | 5 |
I recently had my engine light come on and went to Auto zone where I had their computer talk to mine and was told that it is an emissions problem. Then took the car into Dobbs Auto center and had them run a full check on the emissions. They found nothing wrong. They want me to ...
|
| Cliper Bottom brake bolt - 1997 V6 Camry | 19 Jun 2007 16:38 GMT | 2 |
I was trying to change the rear break pads for my 1997 camry and have accidently worn out the edges of the head bolt on the calipper housing. I have tried to unscrew it by using the grip pliers etc with no vein!!. How can i unscrew this bolt so i can take the capplier of
|
| 99 Camry 4 cyl Tune up | 19 Jun 2007 16:15 GMT | 2 |
I replaced spark plug cables and matched them incorrectly. As I was trying to pull out the cable, the cable came out from crown undamaged, but the crown remained in place. I then fitted cables in appropriate crowns. So far, this has worked fine. Will this work fine in the ...
|
| AC button flashing on 04 Camry | 19 Jun 2007 12:06 GMT | 2 |
I drove my 04 Camry on high water flood road. After I pass the road, the AC button started to flashing, and the AC automatically shut off. Thirty minutes later I stop my car and start again, the AC function came back to normal, and no more flashing. Does driving over high
|
| Are OEM pads *really* necesarry? | 15 Jun 2007 06:52 GMT | 6 |
A friend and I are about to change the front pads on my '99 Camry V6. He's the mechanic, I'm the helper. He owns and maintains his own 2000 Toyota Tacoma, and says any decent semi-metalic pads should work fine. I mentioned that I'd read non-OEM pads squealed IIRC. What's the
|
| 1998 Camry I4 differential | 15 Jun 2007 06:07 GMT | 3 |
I discovered that I was losing differential fluid when I went to drain and refill the dif and only got about 8 ounces of fluid out. I refilled and wiped down everything around the dif. After driving for a few days I found evidence of new Dexron leaking from the driver's side
|
| Filtering Efficiency of toyota Oil Filters? | 14 Jun 2007 20:23 GMT | 5 |
Are the Toyota oil filters any better than typical aftermarket ones such as Fram or purolator standard filters which are 94 percent efficient? I know that some premium filters are 99 percent efficient. I have used Fram filters and wonder if the extra cost of premium filters is ...
|
| ATF metal particles | 14 Jun 2007 03:08 GMT | 3 |
Just pulled the trans pan today and found a lot of fine metal particles stuck to the magnets -- they were really coated with metal slurry. Also some on the differential plug magnet. Pan has never been pulled before, car is 12 yrs old, 178k, 4cyl. Is there a 'normal' amount to ...
|
| Which caliper sliding pin grease to use? | 14 Jun 2007 01:38 GMT | 1 |
The car is a 2001 camry 4 cyl. 82k mi. I'll be changing the front brake pads soon (this is the second set). The brake pads (Akebono ProAct Ceramics from tirerack) came with two one inch tubes of black looking caliper grease which has to be applied to the pad backing
|
| performance pistons? | 14 Jun 2007 01:11 GMT | 2 |
Do "performance pistons" (slightly taller pistons which would give a higher compression ratio) exist for the 5S-FE engine? Having trouble finding any online for the Camry...
|
| How to remove the rear window panel of 99 camry to replace the window regulator | 12 Jun 2007 03:26 GMT | 1 |
My 99 Camry power window cannot go up or come down on driver side rear window. I am thinking to replace the regulator and assembly by myself. However, it seems very hard to remove the plastic panels. Does anyone have experience to share? Thanks in advance.
|