Toyota Camry LE 1999
Problem: The heater fan only works when on the highest speed.
I believe the problem is with the blower resistor pack but I cannot
locate where it is.

The power seat lift motor stopped working on my 2000 Camry.  The fore/
aft and recline motors both still work.  I tested the switch and it is
OK.  I put 12V to the lift motor and it still didn't work.  I called
Toyota to ask how much a lift motor would be.  I didn't think it would

I have a 2008 Camry with the standard single CD player (not JBL upgrade) I
have had the car for about a month and am experiencing the following
problem. After working with no issues for about a week, the CD player while
playing a CD will suddenly make a loud clunk sound.  At this ...

i don't know if my 1999 toyota camry CE has daytime headlamps.how can
i check?

A couple of weeks ago the gas gauge on my '94 Camry stopped working.
It reads empty (doesn't move).  
Any ideas what's the most likely cause?  
An hints one isolating the problem?  If I have to replace the sending

My 2006 XLE, just got it, I have the heat turned on to recirculate, on
my feet.
When I accelerate, the blower speeds up, and when I slow down, the
blower slows down.

Recent problem happened around the same time as check light going on.
When refueling, the gas pump will shut off as if my tank is full, and
sometimes fuel will come out the filler tube. I've tried different
angles of the nozzle and fueling very slowly which helps some, but it

I need to replace the cv joint on my '91 Camry Wagon.  I'm going to
buy a rebuilt half shaft.  Any reccomendations on who carries decent
ones?  Kragens?  NAPA?  Autozone? etc  I've read some have reground
races and oversized bearings.  I just need something that is not

Have a 2003 Corolla automatic - 42,000 miles - now service advisor
wants to flush brake lines  $67.00 + fluid + taxes - I already flushed
rad and tranny  per maintenance recommendations but  see nothing in
maintenance instructions about flushing brake lines - after spending

I hope someone can shed some light on a problem I have with my 96
Camry. The motor vibrates when accelerating through 2,300 rpms and
levels out after. In other words it's fine until it hits those revs,
and then goes away. This will happen when the car is stationary and

The engine warning light on my 1992 Toyota camry V6 XLE is on. Could
this be from a bad PVC? If so where is it located on the engine? What
other problem would cause the warning light to come on?
Thanks,

To replace the valve cover gasket on a '95 V6,
the manual specifies "seal packing" -- part no.
08826-00080, 00258-00103, or "equivalent".
The dealer wants $16.50 for the stuff, which

I have a '98 Camry, V6 with ~123k miles.  Car runs well but has
developed an annoying problem where the check engine light trips with
code P0446 (EVAP) after re-fueling.
I usually clear the code, go through one tank, and re-fill making sure

I have a Toyota Camry, 95, 210Km, 4 cyn, automatic. I recently find
there is an obvious lateral vibration, especially at startup and stop.
I can feel the steering wheel vibrating lateral severely then. Based
on browse search, I find the dogbone is broken. Someone suggests the

I have a 1999 Camry and it has 108000 miles on it. It only seems to
happen when its could out, about 40F and below, but when I first start
the car and start moving and turn the wheel, it squeaks and there is
some resistance every now and then. The power steering fluid if fine,