Ok, probably a silly question, but can I put an aftermarket cruise
control on my manually shifted 94 pickup 4x4?
Thanks

Any one know how to reset the maintenance light on the 04 4runner?
Thx

When I had my Saturn, I discovered that there were about a half a dozen
aftermarket filters that would fit. Two of which were larger in capacity
and filtration area.
Are all filter bosses on the engine blocks the same, regardless of

Any advice on:
1) What brand of front brake pads
2) Where to find step-by-step instructions
3) Whether I need to get an installation "kit" as well

are there any resources on the web that will give me this info?
basically looking for the estimated yearly depreciation charges on the
4runners.
thanks,

I have a 2001 Tundra V8 4X4 with 47000 miles on it.  The check engine light
just came on and the dealership says it is the Oxygen Sensor.  I have heard
of them going bad but not this early.  Has anyone heard of this either?

Does anybody know what needs to be takin off the get to the rear speakers of
a X-tra cab 03 Tacoma?

I just picked up a rebuilt longblock ($975.) and was questioning the quality
of the parts and possibly the workmanship.  They are using what looks to be
a cheap plastic chain guide(hollow on the backside) and the gasket kit
looked to be sub-standard. I wondering my money would be ...

I have a 1987 Toyota Truck with a Turbo engine. The head is cracked and I
have someone that is going to give me an engine from a 1987 (non-turbo)
truck. Will this engine fit in my truck seeing as mine is a turbo and the
transmission is for a turbo???

I have a 1979 Toyota Pickup (20R).  The AC system has been converted
to 134 and works OK... but only OK.  When the compressor is on, it
blows very cool.  But the problem is that the compressor FREQUENTLY
cycles in and out.  I tried adding additional freon, but it doesn't

I'm thinking of getting my daughter a Toyota Tacoma, about a 99 or 2000. any
comments on whether or not this is a wise decision? Are there other makes in
small trucks I should be looking at?
Thx for your opinion, Mike

anyone aware of what might be coming around the corner?
Regis

What could cause low oil pressure at the sending unit and the gauge itself
when the mechanical pump has been checked out and replaced with a new one?
Any ideas?  I've got a 1975 FJ40 with factory compression in all the
cylinders and it runs great. Stock 6 cylinder?  Any ideas?

What would be the average cost of a frame ? & to install it ?
Here In Canada. But I'm open to suggestions.
Thx In advance

Looking to enhance the performance.  Any suggestions for bolt ons.