| Thread | Last Post | Replies |
|
| 2002 Tundra replacement tires | 14 Sep 2004 04:59 GMT | 3 |
Does anyone have any recommendations for replacement tires on a 2002 Tundra 4WD access cab. I would appreciate some advice on tire selections. Thanks Chad
|
| new battery, terminal too small | 14 Sep 2004 04:54 GMT | 10 |
Okay... I got a new battery a while back for my 4Runner, was in a bind and had to get it quickly (borrowed the car's battery to get me to Auto Zone, they took my old one and matched it to a new one) and it seems the negative terminal is a hair too small of a diameter for the ...
|
| Tundra: paint chipping fender flares | 14 Sep 2004 04:51 GMT | 4 |
So I have 5000km on my 04 Tundra DC and I noticed that there are ~45 to 50 black flecks where gravel has chipped the fender flares exposing the black plastic underneath. Anyone else experience this? and if so what fixes are available? I was
|
| Ride height on stock '89 pickup? | 14 Sep 2004 02:11 GMT | 3 |
I'd like to get a few responses to this, so I can average out the results. I have an '89 4x4 pickup with 31x10.5's. My truck seems a little higher than others I see on the road. Can anyone measure the ride heights (front and rear) of their stock rigs? Measuring something
|
| 4Runner running boards | 13 Sep 2004 23:25 GMT | 3 |
Does anybody know how much it would cost to install running boards on a 99 4Runner? Mine came w/o the boards, but I'd like to install them. Also, has anyone attempted to do this on their own or do they have it done at the dealership?
|
| how to remove old Parking brake cable from handle? 93 P/U 4x4 | 13 Sep 2004 11:43 GMT | 1 |
I am trying to replace my broken parking brake cable and I cannot remove the old cable from the back of the Handle inside the cab? I cannot get the little ball/cylinder out of the back of the shaft? does anyone know what the trick is? Please help!
|
| Shift Linkage Rattle? | 13 Sep 2004 01:05 GMT | 1 |
I drive an '85 Toyota pickup, 4x4 with a 22r and a 5spd manual trans. When I shut down the engine the car shakes quite a bit. Not a big deal, but lately I've noticed that the shift linkage seems to rattle a lot when the car shakes. I'm not sure if I'm calling this the proper
|
| Dashoard smoking on 1994 Toyota Pickup - HELP!! | 13 Sep 2004 00:19 GMT | 3 |
Recently, my dashboard started smoking. Only gauge working is oil pressure. I unplugged just the largest plug which was the side where the board was hot in the back and no more smoking - Is this a ground problem? I have in the past noticed my speedometer and RPM gauge drop, but ...
|
| 05 vs 04 Tundra | 12 Sep 2004 22:37 GMT | 5 |
...newbie here - I'm looking at getting a Tundra and looking for opinions about getting an 04 with a good rebate versus doing the best deal I can with an 05? Is there anything about the 05's that make them preferable over the 04's. TIA
|
| '94 4runner blower resistor removal & replacement | 12 Sep 2004 21:57 GMT | 6 |
Has anyone ever done this? I have the new resistor, but having a bear getting the heater/AC unit out far enough to get to the resistor. Any help would be greatly appreciated. Bill
|
| Anybody Parted Out a 99 Taco? | 12 Sep 2004 14:35 GMT | 3 |
I'm looking for a drivers side front parking light / turn signal lens and a set of fender flairs. Anybody have 'em? Thanx- ~s
|
| AC Problem continued from previous post | 12 Sep 2004 10:52 GMT | 1 |
It is not icing up. I have turned the AC off and on when it quits working numerous times. I recently drive over 1000 miles and tried several trouble-shooting methods. During one leg of my trip, when the AC stopped working I turned the AC off for 100 miles. Turned it back on and ...
|
| 4runner automatic to manual conversion | 12 Sep 2004 10:39 GMT | 2 |
My only holdup on this is the cruise control. Do I need to run another switch to the clutch pedal? I haven't seen a manual with cruise, so I don't know about this.
|
| Tacoma Oil Filter Question | 12 Sep 2004 04:33 GMT | 2 |
I have a 2003 Tacoma 4 cylinder 2.4 L . I want to change my own oil and looking at the filter location I'm guessing I will need an Oil filter end cap that attaches to a 3/8 socket?If so what size end cap would this use?
|
| Help?????? | 12 Sep 2004 04:12 GMT | 1 |
I have a 1988 Toyota 4x4 truck with a 2.4L engine. My question is my cluth is going, how much will it cost to replace it and is this something I can do myself without takeing forever to do it? I have moderate mechanical skills and have repaired and replaced just about everything you ...
|