After 20 years finally lost the p/u's sealed beam.   Replaced with a halogen
sealed beam.  Noticed the silver reflective material isn't applied where the
leads come in the back.  About 2" non-reflective opening in the back, light
leaks where hood line meets fender.

When the truck was new and thereafter until the a/c system broke, I was able
to run the air conditioner with the temperature gage set to hot.  I got hot,
dry air which was fantastic for taking the humidity out of the truck during
our wet winters here in Houston.  The a/c system was ...

Using parts from a salvage yard, what would I need to convert my '99 Taco to
manual hubs??

My 88 2wd Toyota truck has alot of rust holes on both sides of the
truck bed.  I patched it with bondo 4 years ago but now it came back.
This time I want to sand down the areas and cut out some of the bad
rust spots.   To patch it would I use aluminum panels and bondo for

I'm looking for rocker guards for my '85 4x4 truck (standard cab,
standard bed).  I want ones that work well and look good.  Does anyone
know of any companies that make them?
Thanks,

Suggestions for brush guards for a 2004 4Runner 4WD?  I'm in the Dallas
area, if you know of any local sources.
Thanks,
Scott

Suddenly my engine would barely idle. Toyota tells me 3 of my
cylinders arent firing. But fuel pressure, timing and wiring to the
injectors are ok. So all of a sudden 3 of my injectors died or got
clogged. Im going with remanufactured injectors witch are 1/4 the

I think I need some help. Could somebody give me a step by step help on how
to change a head gasket on a fuel injected 22RE engine. The truck is a
1988. I like to let you know that this is a first time experience for me.
Hopefully I can do it due to I hear it can be expensive at a ...

Anyone know where I can get online tech info for 83, 22R pickup. I'm
interested in bleeding some air out of the clutch fluid line.
Thanks in advance.

my rebuilt 22r engine runs great until it warms up.  Then at higher rpms it
acts fuel starved.  Slow acceleration, and will sputter like clockwork
about every 3 to five seconds.  New wires, cap , rotor, and fuel filter
were no help.  Local mechanics are stumped.  Any suggestions ...

I drive a 1985 Toyota pickup.  It has the straight axle and the
leafsprings in the front and it doesn't have power steering.  When i
turn the steering wheel hard or at high speed i hear a klunking noise
underneath the driver side of the vehicle.  I can also feel something

I'm finally getting around to putting my 1986 22r carburated engine
back together after replacing the timing chain guides, and, yes, I did
take this groups' advice and ordered the steel-backed ones.  I ignored
both the Haynes manual and the Toyota factory manual and put the head

Does anyone know which fuse handles the cig lighter for a 96 4 Runner?
The manual does not show it.
Thanks in advance.

Any ideas where to get a small amount of Phantom Gray Pearl paint... I have
a few rock dings and scrapes that I would like to repair.  I have the
capability to spray, so I would like the real stuff.  (not aftermarket touch
up paint you find is the stores with a applicator...)

I have a 2001 Tundra SR5 with the V8 and 56K miles. I have an annoyingly
loud chirping noise (like a squirrel cage) when I start my vehicle, and it
does not go away until the vehicle has been fully warmed up, and perhaps
been running for 30 minutes or so (although, now that the ...