hey all. hope you can help me out on this one.
the fuel guage on my dash doesnt move above zero.
firstly i thought it was just low because i hadnt used the truck for a while
but, even after filling up what would normally be about half a tank, the

At what mileage should the timing belt be replaced in a 4Runner 2000? Mine
has 77,000 miles. The dealer says it should be changed. Any opinions, and/or
experiences?

Does anyone know what I can do to improve the fuel economy of my 82 landcruiser?
I have rebuilt the carb twice and that gave me about 5 to 6 miles per gallon.
This is a used vehicle for me so I don't really know what I should get for economy.
Any ideas or hints greatfully ...

Has anyone here put a cap on a 2005 Tacoma?
I'm not looking for a cap, but the details of how the cap installer
attached it to your truck.
Anyone?

I have a 97 4runner that develops a shimmy at 65mph on the right side,
and it's driving me nuts.
This is my daughter's car, so I'm not the daily driver of it.  In the
past few months she's been in a couple of fender-benders with it, one

I am having a hard time finding one of these units that rest on the hump on
the floor in the front. Does anyone have an idea of where to look for one?
TIA

I have a 93 v6 4x4 est. cab and I am redoing my brake calipers on the front.
This truck has the four piston caliper that has two halves of the caliper
held together by bolts. I pulled the caliper off the truck, removed all
fittings, replaced pads, hardware and pins, wire wheeled the ...

I am looking at a 04 Prerunner silver 3.4 auto TRD, with 10457mi, i
realy like this truck. What i would like to find out is 19995.00 a good
price and what are the bad points, if any i sould look at.
 Thanks

I'm now on my 3rd set of halogen headlight bulbs for a 1984 Toyota
truck.  It still uses the conventional H4 wiring.  However, after about
a month of driving, the high beam filaments break (verified by measuring
continuity on the bulb).  The low beams are just fine.

I recently put my toyota colorado in for an mot it failed on the bushes
that are used to mount the steering rack were worn. the only one that i am
able to replace is the D shaped one the other two are part of the rack and
are not sold separately. i have had the rack off and the ...

We need as many as 500 Mack 675 or 676 Turbo Diesel used Engines. Must have
a good block and head. We'll rebuild if needed. Will pay 1200 to 1300 USD
for each unit.
Also needed as many as 500 Big Cam Cummins diesel engine. Must have a good

1996 Tacoma 4 cyl
Starter engages with ignition turned off, only way to stop it, is to
disconnect the battery, I had the starter tested, checked out okay,
disconnected wiring from ignition switch, still, engaged, removed starter

On Memorial Day weekend my 3.0 liter V6 engine seized here in San
Diego, CA with about 172,000 miles on it.  I am the original owner and
it does not seem cost effective to rebuild the engine. Any suggestions
on where to find reasonable priced engine block and right head? Any

I recently purchased the 4 cylinder model of the Tacoma prerunner
series and I was wonder what kind of modifications could I do to
improve overall horsepower and towing/payload capcity.

   How can you tell what kind of fan clutch you have?  I need one for a 98
4WD Tacoma, and all the parts people want to know if it is a "thermal" or
"non thermal"......
   Many thanks,