Can someone tell me where is the PCV valve on the 4runner 3.0L V6 engine?  I
don't seem to be able to find it?
Thanks,
-don

i want to remove the brake light assembly on 99 tacoma in order to install a
roof mounted antenna without  having to take whole headliner out. is this
possible by removing the 3rd brake light assembly and then installing
antenna, and replacing brake light?

I have a '91 ext cab 4wd Toyota PU. I have been looking for some take offs
that will fit the truck. I have a complete set of tires and wheels for a
2001 Chevy Z71. I tried these wheels and they would not fit. Yet I see
several posts on ebay where they say the wheels are ...

My original 22RE blew up and was not rebuildable. I simply had it
replaced with another 22RE.  no matter how much adjusting I do, I
cannot get the motor to idle for more than 2 min. I used all the
original sensors, hoses, etc from the old motor which were working

I let a guy work on my engine and he offered to disable smog control...
  I was like sure, he went and went to work, he clipped tons of wires
that are on that little plate that bolts to the valve cover, plugged
ALL the tubes, and turned on the engine, it seemed to run fine, but now

2004 Tacoma lower ball joint recall
I just picked up my 2004 taco from having the recall for the lower ball
joints replaced.
Now when turning to the right, when I get on or off a "clover leaf" exit

my 1993 toyota pickup 4*4  will not start
i instelled new gas pump and new filter
oppreciate any help.
thank you...

Details on a site:
http://www.autotrue.com/

Who has custom bumpers for the 87 pickup ?

I recently moved to San Diego and I need to get my 1994 4runner worked
on.  I'm wondering if anyone can reccommend a
reliable/knowledgable/fair full-service independant Toyota mechanic in
the Pacific Beach, Mission Beach, La Jolla area.

Hoping for some input on a problem with rear brakes on a troop carrier
[2/91manuf].
Original problem was the escape of the leading shoe on RT/HND Rear set
from the slave , creating a jammed wheel.

I need to pull the front grill work off my truck and I'm stuck. I
pulled off the two side (running) lights and have managed to unclip the
entire top of the grill work, but I can't seem to get the lower portion
disconnected. I can see 4 clips (maybe 3, it's been a couple of hours

Ok, my engine first of all, is running lean, second, it misfires,
third, at 1900 rpm it makes a mean clattering noise. sounds like the
valves, but its not.  when i go down hills i get mean backfires if i
dont give it gas, maybe anyone has any suggestions? oh the truck is a

A while back I had asked a question regarding a problem with the tranny
in my 2005 Taco, V6 6 speed. The issue was that the tranny was coming
out of 4th gear and dropping into neutral. A few others responded that
they were having the same issue. Well, the truck went into the shop

'98 Tacoma. Wiring trailer harness. Standard 4 pin connector.
White/Brown/Yellow/Green. I know the wiring is a little diffrent because the
turn signal and taillights are on sepearate bulbs. Anyone know the sequence?
Thanks.