My '90 toyota pickup oil pressure dial has stopped working after I changed
the oil and filter. I only drove it a few miles when I noticed it was not
working. Truck has 193K miles and new oil seal was put in 3 months ago.
I waited until the next morning so all the oil would be ...

Recently purchased a '96 T100 with a 3.4 V6 engine. The Truck is clean and
appears to be well maintained but has 140k + miles and I am concerned about
the timing belt . Hate to put down 250 + $ right now and was wondering if it
would make sense to have someone pull the Tbelt ...

I'm trying to diagnose a problem with my 86 Toyota PU 22R Automatic, Home
Depot beater.  I don't drive this much on the hi-way, but once in while I
need to get on the freeway.  The engine strains at 65mph. I figured out the
OD button the shifter does not work, nor does the OD light ...

I have a 99 tacoma 4x4 w/ 6inches of lift on 33s. Ever so often i'll be
starting from a stop and I'll release the clutch and my stick will jump
from 1st into neutral. Is that a clutch or tranny problem or both? And
is there a simple test to check my clutch? I have 96K miles.

While driving to work one past morning I watched  as my oil pressure gauge
bottomed out, flat lined. My gut reaction was to "shut 'er down". Now, this
oil gauge belongs to a 90 4Runner with 3VZE engine that has about 90,000
after a factory rebuild. THere is 167,000 on the ODE! I ...

HI;
What is your favorite board for getting advice on repair/maintenance on
Toyota Trucks?  This one seems not bad, but I have the sense that people
have migrated somewhere else.  

I am trying to find out the mpg for the 2006 Tacoma v 6 auto 2 wdrive. It is
listed as n/a on their website

I know this is going to sound strange, but I asked recently about my check
engine light being on and how to correct it. Well,  my gas mileage has gone
UP. According to my calculations I am now getting 19.2 MPG whereas I used to
only get 15-17 MPG. Could it be true? I got 314 ...

Hi;
1994 Toyota 4Runner.  
I have some concern that the timing under control of the ECM is not
working, or not

In effort to fight what we believe to be unfair sales and labor
practices as well as stand up for  Hispanic women's right to work in
a company dominated by white males - Group 1 Automotive, Inc., we're
organizing a boycott of the Group 1 Automotive, Inc. Dealerships.

I am wondering if anyone has heard of the following problem and/or may
know what is going on?
When I start the engine (only when cold and only once per day as far
as I can tell), there will be a strange shimmy/whine that seems to

Hi;
Have a 1994 4Runner that needs one front sway bar bushing replaced.  
There are "upgrade" kits that make this claim:  "Polyurethane bushings are
made to last a lifetime."   They (MAKO) claim rubber bushings don't last.

THe engine light just came on this morning, I know that I have to jump
something, but what pins do I jump and to find out what?
Thanks
Searcher

 I just had to troubleshoot and error code 52 on my truck and found
the following information I thought I would share.  The knock sensor
can be tested by using a digital multi meter like a fluke 83 (cheaper
models do not detect the knock sensor signal).  Put the meter on AC

My current rotors have been cut once and are warped. This time I'd like
to upgrade. Maybe slotted and/or drilled. Any suggestions? A particular
brand? While I wouldn't mind rotors that afforded better braking, I'm
more concerned with one's that might last longer where warpage is