| Thread | Last Post | Replies |
|
| Hybrid 4RUNNER | 20 May 2006 00:01 GMT | 4 |
When is Toyota going to do a hybrid 4RUNNER. Anyone know?
|
| 2003 4runner door locks | 19 May 2006 02:26 GMT | 1 |
My driver side door lock just started to stay locked when the engine is off and the key is removed. Is there a code to use with the remote to change this? John
|
| 4Runner brake problem (odd) | 19 May 2006 02:02 GMT | 7 |
My wife took the 2002 4Runner to a dealer to get the brakes done. They were shot. Everything was replaced - pads, rotors even calipers, brake fluid. Now it's a month and 2000 miles later, I notice vibration when brakes are applied at over 40 mph.
|
| Bad vibration/shaking at higher speeds- help... | 19 May 2006 01:53 GMT | 8 |
I have a 99 4runner limited 4wd. At around 50 to 60 miles per hour I get a violent shaking that pulls my steering wheel back and forth and is even more pronounced when I press the brakes. I had the tires balanced and rotated first and the brakes look and feel fine. Theres no ...
|
| 2001 RAV4 - Rough/Low Idle | 18 May 2006 12:27 GMT | 3 |
Hey everyone, I have a 2001 RAV4with an automatic transmission and 2L gas engine (Canadian market). I have been having what I considered a rough idle for a few years (rougher then it was new, started a year after
|
| Highlander Brake Pads | 17 May 2006 01:34 GMT | 3 |
I have 60,000 miles on my 2002 Highlander 2x2. I need to replace my brake pads fairly soon. I notice some places are selling ceramic pads. Are they any good? Or should I stay with metallic/semi metallic pads?
|
| 1990 truck rear brakes | 16 May 2006 16:49 GMT | 6 |
I have a 1990 Winnebago camper that is built on a 1 ton Toyota truck chassis. I want to check/change the rear brakes. I removed the rear dual wheels and then the six small (12mm) nuts on the exposed end of the axle. Then I took off the lock washers and tapered inserts. The axle ...
|
| 98 tacoma whistle noise after throttle body cleaning | 16 May 2006 16:15 GMT | 2 |
I just recovered my 98 tacoma from my college age daughter. After a thorough cleaning and tune up I decided to clean the throttle body (105,000 miles) Once that was done I started the engine, the idle was a little higher but there is now a loud whistle type of noise from the
|
| best fluid for my Tundra differentials? | 16 May 2006 16:10 GMT | 2 |
At 10k, I am going to replace the oil in my front and rear differentials on my new Tundra. What is the absolute consensus best to use? I am switching to sythetic engine oil at 5 k miles here in a few weeks and I want to do whatever's best for the diff's since I plan to
|
| Toyota Detonating | 15 May 2006 18:57 GMT | 10 |
I need some input on a problem, I have a 2000 Tacoma Pre-runner x-tra cab v-6 , with all options. I bought it new six years ago here in Phoenix. It has been a great , trouble free truck. The truck now has 64,000 miles I have always done most of the service myself. It gets oil and ...
|
| Upholstery - 93 4Runner | 15 May 2006 15:53 GMT | 12 |
Have the stated. 2 dr hardtop Front buckets. Drivers bucket has edge wear that is through the fabric, to the foam. What are my options? (remembering the blue herringbone fabric covering
|
| When should you perform a transmission fluid replacement on the 2004 toyota highlander V6? | 15 May 2006 04:09 GMT | 3 |
When should you perform a transmission fluid replacement on the 2004 toyota highlander V6? thanks !
|
| prerunner | 15 May 2006 02:32 GMT | 4 |
i seen a neat truck at the stop light today its called tacoma prerunner it has kind of a step side look does any one know anything about them
|
| broken spark plug | 14 May 2006 15:50 GMT | 5 |
Anyone have any help? I was changing the sparkplugs on a 1988 4 Runner I just purchased, and the bolt and the end of the spark plug broke off leaving the threaded end of the sparkplug in the head. I have put an e-z out into the broken off section of the sparkplug, but now I have
|
| Brake System Nightmare - 99 4runner ltd 4wd | 14 May 2006 15:37 GMT | 4 |
I posted a thread recently about a front end problem I was having. The front end would start to shimmy at higher speeds. The problem became more and more frequent. Then the brakes started lock down as if the calipers weren't releasing. I gave up diagnosing myself and took it ...
|