I have a 1994 4Runner SR5, 5spd manual, 6cyl w/ 4wd.  The cruise
control no longer works.  When I switch on the cruise control the
green "cruise" light flashes regularly but the cruise control does not
engage.  The car runs fine otherwise and has about 133k miles.  Does

Hi, thinking of buying a 2001 Tundra I have seen, test drove it the other
day, its a one owner, 64K on the clock, has been used for towing, has the
electric trailer brake controler inside the cab.
Its got the 4.7L V-8 auto with O/D. most of the usual goodies.

Does anyone know of an aftermarket fog lights set that will fit a 2009
Tacoma? Toyota doesn't offer a kit for 4-cyl. trucks.

I just passed my smog check, but it was *very* close this time, so
clearly it is time to do some work to clean things up or replace
something.
This is a 1999 Tacoma 2.4L w/automatic.

I need to change the headlight assembly on my 1997 4-Runner. Looking
at what I could. I see that I have to remove the front grill and
probably the piece under the headlight. How do you remove the clips
that hold the grill to the headlight assembly?

I'm trying to help out a friend who has a 1996 Tacoma equipped with a 4 cyl.
engine and 5 speed manual transmission.
The stoplight (15A) and taillight (10A) fuses keep blowing out. Obviously,
that means that there's a solid short circuit somewhere on each circuit.

I'm looking to replace the headlights on my 2000 Toyota Tacoma extended cab 4WD
pickup with new lights. The only way I can describe what I'm looking for is that
I want those lights that appear purple or blue when you meet a vehicle with a
set of them in oncoming traffic. I don't ...

I have a 2008 Tundra and want to install the PIAA driving light kit. Don't
want to use the turn signal light stalk instead looking for an OEM rocker
switch for one of the dash knockouts. Any ideas?

2009 RAV 4 with the four cylinder. It has a different oil filter then
the spin on type. I have Goggled for the correct type of cap wrench
to
remove the housing.I have seen different types, Does anyone have a

Problem:  When low ratio is selected front diff will not engage but
works in high four wheel drive.
Question:  Is low for front diff engaged purely by selection lever, or
is it engaged electrically over vacuum?