Has anybody here any experience of removing and re-fitting suspension bushes
and ball joints in Peugeot 106 (or similar) front wishbones?
If so, can you tell me what press was used and what force?
I know it's a remote possibility for DIY mechanics but it seems silly to

Whats the best fluid for cleaning brake components (not friction matl)
ie from leaking cylinders.
Petrol, Gunk, Parafin or nothing but elbow grease.

can any one tell me how to get the fault codes out off a s reg rover
600 2.0 16v (honda engine) as its running like a 1.6 and a bit slugish.

Our Peugeot 306 1.4 1998 is noticably 'popping' when sitting in neutral
at 2.5k rpm (most noticable then, but certainly present at lower rate at
2k and possibly lower revs).  Car has done about 101,000 miles.
Engine runs otherwise fine, always starts first time and pulls away fine ...

I have an electrical fault with my Clio, only the left hand indicators
work even when you signal right, the Hazards won't turn off the button
will not stay in, and I have no heated rear windscreen.
Could these be from the same fault??

My in-laws have a 98 Vauxhall Vetra 2.0 and they are looking at getting
a 2 berth caravan. They though cannot find details of the maximum towing
weight.
Does anyone know?

There is special offer car battery charger on at Lidl for 9.99 at the
moment. Is it any good?
http://www.lidl.co.uk/gb/home.nsf/pages/c.o.20060413.p.Car_Battery_Charger?OpenD
ocument=&smVars=
Visually it looks similar to the ctek range of battery charges

Hi, does anyone know  what the toe in ( or out ) should be on a 1.8
diesel van, I bought it on ebay and wuz robbed  needed new front bottom
plates which I did but the tyres are wearing on the inside help me
someone!!!!!!

Hi all, what do you all think of the process of running in a car?  I ask
this because this morning I saw a brand new Citroen C2 with dealer plates
being absolutely screwed.  I wouldn't like this to have been my car!
Rob

I bought a ford mondeo estate  diesel 1998 r.reg. The speedo the odometer
and the trip meter are not working. Any ideas,I,ve been told it may be the
speedo sensor as in 1998 they stopped using a cable and used a sensor
instead.

I need to turn one of the front wheels in by half a turn of the adjuster.
Can someone explain how I should do this, please? Is there a danger of
damaging a link (ball joint) and if so how do I avoid that?

I have just fitted a Cobra 3193 alarm to my MX5 (and it works!!). I
want to add the Cobra 5460 Micrwave sensor, but it is not obvious how
to wire it up.
The alarm has additional wires for connecting extra sensors there is a

Just had an MOT, and it noted that the front brake shoes were wearing a
bit thin.
From memory, when I was unsticking the caliper, their was maybe 8mm of
material.

Both my Haynes and Peter Russek manuals say when renewing the fuel
filter on my Xantia 1.9TD loctite needs to be put on the screws holding
the cover on fliter housing. Is this really needed, and why? I fear
never being able to get it off again next time.

I have been offered a company car for business use and have been given
a choice of *any* car within a budget of 60k either as a lease or
bought by the company.
My requirements are that the car should not be too large (to allow for