Hi group,
Can anyone point me in the direction of the wiring for an accurate rpm
signal on a Fiesta 1999 1.25 lx. This is for an SGI LPG conversion.
I've got three wires multicoloured going into the coil? Or where is the

Just been emailed this::
DRILL PRESS: A tall upright machine useful for suddenly snatching flat
metal bar stock out of your hands so that it smacks you in the chest
and flings your beer across the room, splattering it against that

Dear Mondeo friends,
My Mondeo 2 liters diesel of year-end 2000 has almost 220 thousand
kilometres on the counter and has given me only little problems over
the past years. Currently I have a very disturbing problem with the

I have a 5 door  1998 Civic with 33k genuine miles.   The air-con
stopped working last autumn and a leak test recently confirmed the
condenser needs to be replaced.  I'm told the dryer also should be
replaced.

Two questions:
1         I'm trying to remove a rear brake drum from my AX - I've
undone the hub nut and used a puller and freed the bearings from the
stub axle.

i hate the beeping noise that the clio makes when the saet belt isnt
on, how can i get rid of this disasterous racket.

I got a Renault Megane Coupe 1999 (UK) with a dodgy front wheel bearing.
How hard / difficult is it to replace this myself, and do I need any
special tools.  Local garage qutoe me £200-00 for this.  A new bearing
cost £25-00, so it would be great to do this myself and save a bit of

2001 VW Bora Sport 2.0 AQY 115bhp
Problem: Engine management light keeps coming on
VAG-Com to diagnose
16556 - Fuel Trim; Bank 1: System Too Rich

Punto 1.2S 98(T) 43K miles
My wife asked me to have a look at her Punto as she said it was a little
lumpy on first start up.
Started the beast up and sure enough a misfire on initial startup that soon