| Thread | Last Post | Replies |
|
| Overheating problem.... | 03 Feb 2007 11:55 GMT | 26 |
Nissan Sunny was overheating, water (and steam) coming out of leak in bottom of radiator. Took car to local garage for full service plus overheating problem, full service was done everything fine, garage replaced radiator but said car is
|
| Induction kit for a fiesta!? | 02 Feb 2007 20:27 GMT | 10 |
I am not a boy racer....but.....was curious if I could fit a pipercross induction air filter to my rusty old mk2 1.1 fiesta. Many may say "whats the bloody point" but I just want to add a little bit of spice to such a dull car (I hope she can't read my thoughts, or she
|
| ABS PROBLEM | 02 Feb 2007 20:09 GMT | 4 |
Hi, i have a Rover 220 turbo Coupe and i´m having problems whith my ABS system and i don´t have a clue how to solve my problem,if i take my car to a Rover assistence (in Portugal) they will rip me off for sure(one time is enought) they don´t know how to work in this car
|
| fiesta hesitates on accel | 02 Feb 2007 19:54 GMT | 2 |
hi i have a 1995 1.4 si fiesta which hesitates at about 2500rpm on acceleration if pedal is pushed to the floor it will eventually accellerate qiuckly, and when warm hunts badly on tickover.
|
| astra mk3 brakes | 02 Feb 2007 19:38 GMT | 3 |
can any one help my brakes are rubbish. I have had new master cylinder,brake pipes and disks and pads. they work ok on short journeys but long they overheat and go spongy. any ideas and any info on bigger brake transplant
|
| Proliferation of lights | 02 Feb 2007 16:56 GMT | 64 |
Quite recently I've noticed that many more cars are sporting below-bumper lights of various types - fog, spot, poser etc. Is there any reason for this proliferation? Has there been a change in lighting regulations to justify such an abundance of lights?
|
| vauxhaul cavalier | 02 Feb 2007 13:20 GMT | 2 |
misses let my cavvie run out of petrol and now it wont start. The starter motor is turning and everthing else seems fine, but it dosen't seem to be able to pull the fuel through. Can anyone advise. Ta
|
| Main beam warning light.... | 02 Feb 2007 10:47 GMT | 15 |
I have a W reg Nissan Micra that has the following problem... Using the headlight switch to flash the main beam and it works fine with the blue warning lamp coming on and then off with the use of the switch - no problem.
|
| Micra (K11) Clutch Swap | 02 Feb 2007 08:26 GMT | 2 |
I need to change the clutch on a Micra (K11, 1.0, 1993) in the very near future. The Haynes manual (bloody hell - when did they start printing them on toiler paper?) is very comprehensive, and it doesn't look too bad, except for a lot of fannying about with front suspension bits and
|
| help - ford focus seat belt cover removal | 02 Feb 2007 07:48 GMT | 2 |
I have a 2006 Ford Focus II (europe), 5door. Recently I'm having a problem with a rattling noise coming form the interior B-pillar trim where the seat belt hanger is. In order to eliminate this noise I tried to remove this seat belt
|
| Low Maintenance Reliable Small Hatch? | 01 Feb 2007 22:30 GMT | 33 |
I just wondered what you would recommend as a low maintenance reliable small hatch? I was thinking of something of a similar size to a Megane, Civic, Golf size.
|
| Mondeo Misfire (surprise surprise) | 01 Feb 2007 20:54 GMT | 17 |
Right then.... I bought an N reg Mondeo 2.0 GLX the other day and it's got the infamous misfire :( I've checked the plugs and leads, leads look like the original ones
|
| It cant be global warming | 01 Feb 2007 19:13 GMT | 8 |
My wifes 2005 vectra indicates an outside temperature 0f 67.8 deg C,the obvious thing is the thermistor under the front bumper has anyone had the same prob and fixed it by replacing it ?. There probably not that expensive but to avoid wasting time I thought it
|
| MY CAR WONT START | 01 Feb 2007 13:34 GMT | 2 |
hi im having problem with my honda civic vti eg6!!! my car wont start, i had to rewire my whole car as the previous owner cut it all (dont know why) but the only wirring harness i could find was one with an immobiliser
|
| How to protect the surface of alloy wheels | 01 Feb 2007 11:55 GMT | 9 |
Anyone got any recommendations as to how best to 'seal' alloys wheels to proect them from brake dust etc' cheers DW
|