| Thread | Last Post | Replies |
|
| Transmission Woes | 31 Mar 2007 22:41 GMT | 15 |
So, to recap: earlier this week I managed to drop the plastic drivegear off the speedo drive of my Skoda Felicia (1998 1.9 diesel, non turbo, VW engine, engine code AEF) into the transmission. Since then I've been driving it hoping that the gearbox would just mash the plastic to ...
|
| New Astra Mini Review | 31 Mar 2007 22:39 GMT | 1 |
Not as bad as I expected. Still shite, though.
|
| difference btwn mark 6 & mark 7 fiesta | 31 Mar 2007 21:58 GMT | 1 |
i have a 2006 mark 7 fiesta. haynes last manual is for fords till 2005. would the haynes manual for the mark 6 fiesta be useful for a 2007 mark 7 fiesta?
|
| Punto differential - Help urgently please! | 31 Mar 2007 21:41 GMT | 10 |
Took my Fiat Punto in for a clutch repair, and the garage said that there was also a problem with the gearbox. What they said was 'the crown wheel has sheared off the pinion' because of a sheared weld.
|
| Ka - Water in drivers footwell | 31 Mar 2007 19:23 GMT | 11 |
My "ex-wife-to-be"s 03 Ka has started getting water in the driver's footwell. It doesn't have antifreeze in it, so it isn't coming from the heater matrix behind the centre console - thank goodness. It is therefore probably rain water, but the door and windscreen seals look
|
| fiesta door handles | 31 Mar 2007 18:05 GMT | 2 |
These, I'm told, are a comon fault with Fiestas, inthat they don't work! - P' reg, 96, not sure what Mk.... The handles (drivers side and passenger side, front - rears work fine) operate by pushing a thin metal bar downwards, this bar is inside a plastic
|
| choosing optional extras and factory production runs | 31 Mar 2007 17:49 GMT | 3 |
when choosing optional extras and internal trim colors, would choosing a weird combination delay your cars production and delivery? are cars produced and painted red ones first, then blue etc? or are they just made on the assembly line as the orders come in with the
|
| Fiesta Finesse LX 1.25 2003 | 31 Mar 2007 17:37 GMT | 4 |
Got a Fiesta Finesse LX 1.25 2003 reg, it seems to have a fault... When accelerating, the acceleration is not smooth it seems jumpy, and when in neutral at a stop, the car pulses/throbs and the rev counter jumps around the 1000 mark...
|
| cv gaiter | 31 Mar 2007 15:29 GMT | 2 |
I've just noticed that the nsf cv gaiter has 1.5" split in it. There's a fair amount of grease leaked out of it around the hub carrier and suspension arm but the CV joint is still lubed up pretty well. It had an MOT a week ago so it's pretty recent. Problem is that I need the
|
| Can exhaust/manifold hole cause 'wobble'? | 30 Mar 2007 23:40 GMT | 7 |
have had everything else checked out but my scenic still wobbles between 60-65 and then stops at faster speeds. Can a hole in the exhaust / manifold (which it has got) cause this? L
|
| Dodgy petrol and a still sickly vauxhall zafira. | 30 Mar 2007 22:35 GMT | 14 |
Folks :- On the 10th February I filled up my 1.8 2001 Zafira at Morrisons in Norwich. 50 miles later the emissions warning light came on. The car continued to run OK but it became noticeable over the following couple
|
| MOT oddness | 30 Mar 2007 22:09 GMT | 15 |
I suppose I shouldn't be surprised, but I did a quick check on the MOT history of the 156 this evening.... Last year, it was given advisories on perishing front suspension bushes. I told my wife not to worry about them until the suspension became noisy
|
| Renault Espace dashboard | 30 Mar 2007 17:41 GMT | 2 |
The electronic dashboard on my Espace (registered in Jan 2000) ha started to play up by not coming on at first and then eventuall working. Surprise surprise the local dealer wants to charge £800+ fo a new one. I have found a firm down in Kent will repair it for £15
|
| how to replace a VW polo wing mirror | 30 Mar 2007 16:54 GMT | 1 |
The near side wing mirror is broken. I have purchased a replacement. How do i remove the cover to remove/replace the wing mirror
|
| Fiesta ISCV | 30 Mar 2007 16:32 GMT | 10 |
Hi Guys My sister's 1997 Fiesta 1.3 stalls often when coming to a halt. Otherwise it starts and runs pretty well. First thought is the idle speed control valve. Can anyone describe to me where it is, what it
|