I suspect the front right disk of my 53K-mile, 2000 Focus LX 1.8
Petrol (with ABS) is bent. I reported on problems with the middle
bearing 6 months ago which, through misdiagnosis, led to replacing all
three front bearings and the right driveshaft.

As the title would suggest, I have got a 1995 Mondeo which seems to
have finally given up the ghost. It has been playing up for 3 weeks
now, taking its time to start in the mornings. But this morning it
would not start at all. Took the spark plug out to check for a spark,

One area of the car that always suffers in my ownership is the paintwork. I
love my Zaino polish that brings a DEEP WET shine to even my old
non-clearcoat paintwork but the paint is really starting to suffer its age.
Its going dull in patches and it absorbs oil and grease like a ...

I had to remove some glued on trim from the front of my van to do some
repairs to paintwork. Any suggestion what to use to stick it back. Something
that will last, not dry out or deteriote with heat, ice rain etc. The old
stuff VW used was black and slightly rubbery.

can someone please advise if they can on where the tdc plug is on the block
is on a mk2 2000/w Eudora 1.8 engine
On the mk1 the Haynes manual says its under the alternator but the mk1 I had
is was under the injection pump

A tad off topic I know, but I saw an item on the BBC News this evening <
http://www.tiny.cc/7uf83 > and wondered if cars are now heading in the same
general direction as the cheap disposable supermarket TV?
The item said that the Chinese are planning to produce even cheaper vehicles

Piece of cake, I hear you say, and so it should be. Took out battery and
battery tray, slackened bolts on cylinder, but do you think I could remove
the union from the side of the slave cylinder?  Could I buggery. Anyone care
to enlighten me as to how to remove this so I can take ...

I've just completed a cam belt change on a Rover 420 (2.0l T-Series petrol
engine), and am a little suprised that the 'automatic'cam belt tensioner is
bolted in place. I removed the tensioner to check it over, then once it was
back in along with the new belt, put a new spring on ...

After the aborted attempt to adjust the valve clearances at the weekend
it now misfires intermittently independently of the engine speed.
Another reason I gave up trying to adjust the clearances was that one of
the spark plugs refused to unscrew, my breaker bar wasn't to hand and I

1999 Vectra 1.8 LS Petrol. There are two switches on the dashboard for
the air conditioning. Both switches fail to light up when depressed. I
am aware that one switch can fail, just like that, but why should both
fail at the same time.

I've noticed today on a couple of Surrey police cars a small black box
on the roof at the back on the drivers side.
On the way home from work, I spotted a police car parked up at the
road side, the bobby looked like he was looking at something on his

I have a Peugeot 205 1.4 Forever from 1994. Runs like a dream!
But the speedometer has stopped working at all. I tried to remove the
speedometer cable today, and it seems to me like it's working fine (when
I rotate one end, the other end rotates accordingly).

The problem i have is that my windscreen wipers stop anywhere on my
windscreen and wont go back to there resting point when i switch them
off.. when i put them on they are very slow and judder on the first
setting and the other settings they are fine to swipe the windscreen but

I've bled the brakes and then tried bleeding the clutch on my '94
Mondeo. After the fluid came out (not a lots of it) due to a depressed
pedal, I've lost all the pressure in the clutch (reservoir kept full
all the time).

i have a problem in audi A4 1.8T (2002). i hope some one can answer me and
really
appreciate it.
what it does is....when u run the car some time and stuck in a traffic jam