| Thread | Last Post | Replies |
|
| Ford Mondeo V6 won't start. | 09 Apr 2007 22:28 GMT | 8 |
The engine turns over easily enough but there it just won't fire. I have checked all the engine management related fuses and relays as best I can and they all seem fine. The battery had just been recharged and refitted. I started it up and
|
| MOT queries | 09 Apr 2007 20:18 GMT | 18 |
I'm a newbie on this site but feeling ignorant and potentially cheated, so wanted to ask for your advice! Have just had my MOT failed for a cut in one of the tyres. It was tested today, but the certificate doesnt run out until 11th April.
|
| Senator, Carlton, Omega autos | 09 Apr 2007 19:40 GMT | 5 |
A project for this year is to fit a four speed auto to the SD1, and I'm told there is a near identical GM four speed fitted to a Carlton. In other words, by simply swapping the bellhousing, it fits the Rover V-8 without any mods at that end of things - it's basically the same GM ...
|
| 2002 Passat front suspension | 09 Apr 2007 11:29 GMT | 3 |
I'm about to change the front springs on my Passat I checked to see what I need to do for the job and I note that the upper spring plate needs to set at 11 deg ± 2 deg. I assume that if I place a mark on the plate and other related parts with paint when I reassemble the strut as ...
|
| Ford Fiesta Automatic CTX blues | 09 Apr 2007 10:59 GMT | 6 |
I have a 1997 P reg. Ford Fiesta Automatic. I just bought the car and notice that it sometimes stalls when cold and put into Drive in about 80% of the time. It has never stalled when put into Reverse and has stalled when warm in about 5% of attempts.
|
| Vectra 2.0 DTI | 09 Apr 2007 10:33 GMT | 1 |
I have a Vectra 2.0 DTI 1998, it runs very smoothly, it is almost 138,000 miles. yesterday I went to KwikFit to change oil and filter and the worker there told me there is some oil leak coming from the engine block somewhere. I am not sure where it comes from as it seems
|
| Engine Reconditioners | 09 Apr 2007 10:25 GMT | 1 |
Anyone know of a decent Engine Reconditioners around Yorkshire area?
 Signature Conor Light travels faster than sound. This is why some people appear bright
|
| mk3 1.8 vw golf,idle going up an down | 08 Apr 2007 22:02 GMT | 1 |
Can someone please help. when i sit in idle,my revs go up an dow between 800-1000,why would this be happeneing? How can i fix th problem --
|
| parts help needed - air intake | 08 Apr 2007 20:23 GMT | 9 |
parts help needed - air intake not being great on the modern cars (im getting old ;-) )) i thought i would see if anyone can tell what these parts are and what they are for.
|
| Fan permanently on on Rover 25 | 07 Apr 2007 19:13 GMT | 5 |
The fan on my wifes Rover 25 comes on when I start the engine, and stays on until it is turned off. I suspect (obviously) the temperature sensor has gone, but when I looked for it I found two sensors attached next to each other, one coming out sideways from the pipe, and the ...
|
| Ford Escort XR3i | 07 Apr 2007 16:48 GMT | 2 |
I perform maintenance on Ford XR3i RS Turbos if you have any difficulty, you can contact me by clicking this link www.3day.co.uk/nazcars/
|
| 'Motoring Accessory Stores' | 07 Apr 2007 16:42 GMT | 11 |
Are all, without exception, a bunch of useless bastards. My local motor factor closed down last year, so I don't have anywhere I can just pop out to anymore. I need 4 x rubber 'doughnut' type exhaust hangers.
|
| Gunky water | 07 Apr 2007 01:22 GMT | 8 |
I was checking the car over yesterday and went to fill up the radiator. I noticed the water was quite gunky, mucky and also noticed some guey stuff on the cap i removed. Anyone know whats causing this? There wasnt a lot on the cap only a small ammount but the water was very
|
| Ford Escort Brake Cable | 07 Apr 2007 00:15 GMT | 1 |
Replacing the parking brake cables on my R Reg Estate and I'm after a bit of advice. The replacement cables are of different lengths, about 2" difference. Does the shorter cable go to the left drum to matcxh the slightly shorter run?
|
| One alloy required Kahn rsr 17" | 07 Apr 2007 00:05 GMT | 18 |
Due to a speed retarder I now require one alloy 17" Kahn rsr second hand would be ok or cheapest place for one online, anyone know of a supplier. Thankyou Richard
|