| Thread | Last Post | Replies |
|
| Removing serpentine belt on Audi A6 V6 2.6 litre (1995) | 05 May 2007 14:29 GMT | 10 |
Sadly, no Haynes manual available for this engine. How would one relieve the tension on the tensioner? Simply by unbolting the one bolt? Can it really be as simple as that?
|
| Nissan Primera Question | 05 May 2007 08:23 GMT | 4 |
The wife has an 04 Nissan Primera that is showing a service is due every time I start it. The car has just been serviced by a non Nissan dealer but they haven't reset the message. I had the same problem with her Astra last year and it was dead easy to fix. Does anyone how
|
| Diagnostic OBD11 port on Honda Accord 99 (European) | 05 May 2007 00:42 GMT | 2 |
Does anyone know where the OBD11 diagnostic port is on the Honda accord 99 (european model)? I've heard people say its below the drivers side dash board towards the bottom left, but i cant find it. I've checked everywhere including drivers side bottom left & rigth and
|
| Capper strikes again... | 04 May 2007 23:19 GMT | 14 |
(For those who don't know, I call my car Christine after the Plymouth in the Stephen King film. She bites everyone in the arse who puts a spanner to her) Went to Specialised Engines to get a recon engine fitted yesterday. Was
|
| Nuts? | 04 May 2007 19:55 GMT | 33 |
Does one use std wheel nuts or special sleeved things on these Ex Pug ally rims look like I've bought myself (in the hope I can find some suitable tyres to fit the Ranger kit car). They look like this but are 4 stud ..
|
| Bacon butties again | 04 May 2007 19:39 GMT | 21 |
Has anyone here tried Reggae Reggae Sauce on a bacon sarnie? Any good?
|
| Cat or no cat | 04 May 2007 18:25 GMT | 2 |
so if a diesel car needs a new exhaust and the original had a cat could a new exhaust be fitted with a repair pipe section instead of the cat and then pass an MOT Would performance be affected?
|
| vinegar in screen washer bottle | 04 May 2007 17:41 GMT | 18 |
Now there is no more snow and ice (London) I've stopped using my Decosol screen wash. But just using plain water, I find leaves the screen a bit smeary. It's been suggested to me that I put a bit of vinegar in with the screen
|
| Info about engine from 1970's Rover SDI | 04 May 2007 17:12 GMT | 3 |
Hi A friend of mine has built a kit car and used an engine from a Rover SDI 1970's vintage. It is a V8 but would like to know the following. Was it built by Buick or Rover.
|
| Squeak under and right of engine when in neutral. Vw polo GL 1999 | 03 May 2007 21:53 GMT | 3 |
Hi. A few days ago I noticed a squeaking noise below the engine to the right when I start my car. The squeaking is not constant but comes in 2 second bursts. It is more noticable when I first start the car and doesn't happen when I am driving. It sounds like some kind of belt
|
| 15", 4-1/4 PCD, 4 stud, RWD type offset wheels? | 03 May 2007 11:39 GMT | 42 |
Still in my quest to find an mild 'off road' / M&S pattern tyre for our MK2 Escort based jeep it was suggested that I might have more luck with a 15" rim. So if we were going to a more 'army' look (daughters idea and a cheap
|
| Bacon Buttie | 03 May 2007 00:31 GMT | 98 |
Four thick rashers of dry cure back bacon, fried chestnut mushrooms, fried tomato and a runny fried egg on a toasted ciabatta with tomato ketchup and Encona hot pepper sauce. Is it possible to make a better bacon buttie than that?
|
| fiesta 1.25 rear axle nut? | 02 May 2007 23:57 GMT | 3 |
thinking of changing the shoes on my 02 plate 1.25 fiesta. the axle nut looked like it had a retaining cage around all sides of it so i opened up the cage and undid the nut only to find it is not one nut but about 6 thin nuts. in the end my socket is not deep enough to reach the ...
|
| Fiat Cinquecento scrap value | 02 May 2007 20:05 GMT | 4 |
My brother's scrapping an N reg Fiat Cinquecento. He's been offered £50 & take it away. Given it's a Fiat, and I think he's got 2 keys, is it worth any more, just for the ECU and the keys?
|
| Mondeo cruise control | 02 May 2007 18:04 GMT | 3 |
I have a 1998 Mondeo, the cruise control did work and now it doesn't. The indicator lamp does not illuminate to show its switched on. Any idea where to start looking, thanks. RD
|