Anyone know of a biofuel station in the birmingham area
--

The 406 forums seem to be a bit useless, so I'm asking here. The car is a 53
plate (that's D9, Peugeot spotters) with the 110 HDi engine.
1) The trafficator stalk seems to be a bit too easy to move, and if you wind
lock off quickly it likes to go straight through the central ...

Power loss sluggish to pull away hesitates, if i put my foot down it
starts to pull away then goes flat on me, really anoying wouldnt dare
to try and overtake in it.
Local garage took it for a spin and suggested injector problem any

Went round to local car spares to order a clutch kit..
These are the numbers i saw on the top of the block KJ25943A  and further to
the right ST196533(or 5 most likley i think)
He couldnt find any matching numbers to relate to in his book, either ford

Anyone used the breathable type car covers when laying up an old car? What
sort of problems can you get?
Graham

Carl mentioned pads being sided. Here are the pads for the ZX:
http://i250.photobucket.com/albums/gg258/gtijon_photos/brakepads.jpg
When I stripped everything down, the pads were arranged so that the pads
with the meandering clip (right hand side of the picture) were on the

 I'm looking to fit a towbar to a 2006 Passat estate and in order to do
that I'll need to remove the bumper. The screws round the bottom & wheel
arches look pretty obvious but I can't see how to release it around the
top - I expect the rear light unit will need to come off but ...

I'm looking for the pin out of the three plugs which fit into the rear
of a Ford 4000 RDS radio cassette unit please. I just want to do a
bench test on one.
Failing that.... I have guessed at the +ve ignition supply as the upper

It's all in the subject line really.  This is a 1998 1.25 Ford Zetec
Engine from a Fiesta.  Mine now has no compression on cylinder 2
Recommendations welcome.
Thanks,

My P reg. 306 D went through another MOT today ( it had to have a bit
of fiddling with the brakes and a bulb or two)
I had a problem with it not starting yesterday though, the engine was
quite warm and it was cranking over but not firing. I measured battery

I'm going to use some flushing oil in my campervan's 6 cyl 2.4l non-turbo
engine today (VW LT35). Its had a problem since I've had it where the oil
pressure light takes 5 seconds to go off when started for the first time
from cold. Its a big old lump and done very few miles and sat ...

Any lock experts out there? I have been trying to get the lock on the back
door of my van open for a few days. I've oiled it, put grease on the key and
worked it in, but it will not open. Its the type with the key barrel in the
handle. The barrel twists about 70 degrees and the ...

My car radio has a combined on/off push-button and rotary volume
control.  It's become progressively more difficult to turn on and off
over recent months - you have to push increasingly hard to get a
response - to the extent that it's now almost unusable.  Rotary (volume)

Dent removal with dry ice.
http://www.videovat.com/ug4083/remove-car-dents-with-dry-ice.aspx