I need to put spacers on alloys on the back of our car, just a few mm,
there's a bit of rubbing under load.
Do I need to do the front as well, is it important that the wheelbase is
square?

i am a student of electronic engineering and currently working on my
final year project based on electronic fuel injection system, i am
using an AIR FLOW SENSOR by DENSO, but i am unable to find the data
sheet from this sensor. if anybody here got it then plz send it to me.

My car has just failed its MOT.  As the car is 10 years old and the
repair costs are likely to be too high, I will be taking the car off
the road and possible scrapping the car.
The tax runs out the end of next month, should I do the SORN now or

Hi all, just after a bit of advice if you don't mind.
Took car in yesterday for a service (Just to keep book stamped as its less
than 3 years old), and I really have a feeling that they haven't done it.
Car is a 2.4 diesel, and it was it's first (2 year!!!) oil change (Although

Manged to break the casting of the MIL's 1.3 M Plate escorts alternator
while trying to change the belt (don't ask, I was being a little heavy
handed)
Lower left side mounting and just less than a1/3rd of the casting has come

My parents recently returned from holiday (only 2 weeks) to discover the
Fiesta battery totally flat and unable to turn the engine over.  They don't
believe that any electrickery gizmos or lights were left on.
What is likely to cause this?  The car is only 2 years old although it ...

2001 Focus 3 door. Where is the bloody thing? The filler tube disappears
into the n/s wheel arch but no washer bottle is visible looking there. I
imagine it's behind the arch trim somewhere. Need to get at it because the
pump works but nowt comes out front or rear barring a ...

Righto chucked it on the charger and it now says its fully charged and has
gone into float mode, its currently reading 13.28v which is a lot better
than the 10.55 volts it had. So I guess this means I'm lucky to not have a
bad cell ?

If you leave a car batteyr syanding in a cupboard at home for a prolonged
period will it remain at 12.whatever volts or will it start to die ?

Hi all, can anyone tell me how to reset the check engine light on a 2004
nissan primera SVE? I know there's no fault, it came on because I turned the
ignition on with the injector wiring harness disconnected whilst checking
injector wires whilst doing an LPG conversion. Any easy ...

Our Mondeo Mk2 has bust a spring. A helpful friend reckoned I'd be best
off swapping the whole strut, which I'm now starting to question.
Anyway, I picked one up from the scrapyard yesterday, then realised it
was a non-ABS one, whereas the car has ABS. Top halves are the same, but ...

I tried to help a mate who runs a garage today by pushing the rear
stub axles out through the bearings on a pair of hubs for him using my
10 tonne hydraulic press.
He gave them to me to do because he felt the new hydraulic puller he

Has anyone got an idea of price for one? I don't have the reg number handy
and the dealer can't tell me without it....
Thanks!
Mike P

Folks, how easy is it to replace the wheel bearing on an Audi 2.6 V6
cabriolet?

Anybody know the service items that are checked/replaced on a 3 year service
interval
For a Suzuki Swift 1300cc (new shape)
I’ve been quoted £189.00 for this at a local dealership.