| Thread | Last Post | Replies |
|
| Oil filter cup | 22 May 2008 16:40 GMT | 1 |
Good grief, just how tight can you get the oil filter cup screwed onto its mounting base? Got the 2004 XC90 serviced for the 60K mile mark a few months back. It is ready for an oil change and getting that oil filter cup off is just not happening.
|
| volvo 240 seals/oil | 21 May 2008 01:51 GMT | 5 |
I changed the engine oil. The new oil is: Castrol gtx 15w40 High Mileage oil. Someone said to me that it´s not wise to use that kind of oil, because the "seal conditioner" in the oil will ruin all the (new) seals. (at this
|
| Central locking problem volvo v70 xc | 20 May 2008 21:07 GMT | 3 |
vOVO V70 XC 2.4 2000 I have have a problem with my nearside door locking,when I press the fob it depresses the doorbutton but it dosent stay down it pops back up after a second, all the other buttons remain depressed/locked.Can
|
| Changing the Timing Belt | 19 May 2008 18:47 GMT | 3 |
How hard is it to change the timing belt on a 1990 Volvo 740GL? I know where the cover is and the two bolts holding the cover on but everything is just soooooo tight. It seems that all the other parts with belts at right up against the timing belt cover.
|
| Looking for 1990 740 info | 19 May 2008 18:39 GMT | 3 |
I am looking at a high mileage (~225k miles) 1990 740 sedan w/ the auto gear box. I am wondering what I should look for. The body is in good shape for the age, but that's not everything. I am not familiar at all with Volvos so any information you could offer would be great. ...
|
| Looking for fuel shut off for V40 1997 | 19 May 2008 03:30 GMT | 2 |
Anyone know where can I buy a fuel shut off for my V40 1997. Thanx
|
| any 93 940t used motors out there in "volvo land"? | 19 May 2008 00:54 GMT | 2 |
I am looking to get a 1993 940t replacement core motor shipped to me in colorado....My 93' 940t has over 270,000 miles on it and is smoking bad...it needs rings, pistons, seals, etc.....I am thinkin' a core w < 100k
|
| volvo 240 power steering oil. | 18 May 2008 22:56 GMT | 3 |
Ik have to add a little power steering oil. The power steering is ok, but the fluid level is a little too low. Can I put some ATF-F (same as the oil for the "manual mainshaft") in the fluid reservoir? volvo240 polar 1993
|
| VOLVO 940 PROBLEM PLEASE HELP | 17 May 2008 17:22 GMT | 3 |
Hi I have a Volvo 940 (1991 turbo model) It starts first time every time but today it seems to have lost a lot of power. The turbo kicks in but seem to stutter (best way I can explain it)
|
| FS: new parts for 1985 740 | 16 May 2008 23:45 GMT | 2 |
My daughter just wrecked my beloved 1985 740. New parts that I never got to install: *Timing belt (list $27) PN 48-47520 for '85-'92 740 *Timing belt tensioner (list $42) PN 46-36633 for '85-'92 740
|
| volvo problem | 16 May 2008 22:09 GMT | 3 |
hello i have a volvo v40 19 td 1999 car runs and starts fine but it has ganed a ticking sound on the engine what could this be ?
|
| V40 20T auto - warm start problem | 16 May 2008 22:07 GMT | 1 |
Have a 1997 v40 cd auto when engine is warm it will not start without pressing the throttle and then leaving it running fast without engaging drive, then after a few moments it settles to a steady tickover.
|
| Cost to replace an S60 siren | 16 May 2008 17:23 GMT | 3 |
Half a year ago my s60's alarm started going off randomly. Rather disconcerting, it was. Bottom line, I took it to the dealer and after some diagnosis they found the siren itself was defective. To my surprise, the bill came almost to $500, $170 of that for
|
| groaning during braking | 16 May 2008 17:12 GMT | 2 |
Took the v70 in for an oil change, the tech said a rear caliper seized and was able to free it up and changed the pads. Following this the car makes a loud groaning to shuddering noise from the rear brakes but only if the car has been driven for some distance
|
| 2003 XC70 hot start noise | 16 May 2008 16:35 GMT | 1 |
I have a 2003 XC70...with 100K miles. Love this car! However, I’ve had the car back to the dealer 3 times for a ’hot start’ problem. The car makes a noise (knocking/clanging) upon firing ONLY when the engine is hot and has sat for 30-45 minutes. The noise stops in about 2
|