Hi there, Ive never seen this set up before, I bought a non running 91
vw golf with different cam gears. It was also missing the idle air
control valve and the PCV valve was entirely missing. The vacum lines
on the intake manifold have been plugged for the PCV and the idle air

Just replaced my fuel injector holders and the orings.  On the 1984 and some
of the 83s gtis the fuel injector holders are long.  A long tube with a
round hole in the end for the fuel to come out.
all other A1s from 77 on have the standard short holders, and I think some

I am looking for :"alternator pulley" for a 1981 Rabbit diesel pick up
with ac,  please help me find a "used" one since the dealer or
volkswagon does not make them anymore.
PLEASE HELP!!!!

Hey everyone, I am new to "water-cooled" VW's so standby for some questions
concerning my wife's Passat.  Probably starting with the oil required, lol.

   I was ondering if any of you guys would know what causes this
problem?
The Car is an M reg Golf Gti Mk3 2.0 8 Valves, and when I went to
start the car, it started, and just died.

ive got a 2001 2.0 litre volkswagon bora that shows the engine is
overheating after about two minutes.anyone got any ideas?

I want to get more into the depth of my vw with setting, clearing error
codes etc but I belive I need the software and a special cable for the
software in the subject line.
Can anyone advise me on what I need please.

I'm after a used or new (but cheaper than the £70 VW want!), boost control
valve (N75) for my 2.5TDi T4 with an ACV engine. Does anyone know if the N75
valve from other VW models is suitable? Breakers round here don't seem to
have many TDis or T4s.

I have a 1984 GTi Rabbit.
For the past month or so the car is difficult to start after it sits an hour
or more.  What happens is that the car starts right away and then dies after
5 seconds or so.  It will start right up again and then after a few seconds

I have a 1985 vw cabriolet. i am gettng no spark and have traced back
the problem to be the hall sender. i got the circlip of and after much
looking found the little screw hidden under the rotor. now i cant get
past this how do i remove the metal round puck thing off the shaft and

Recently I had the oil chacked on my 83 rabbit because the oil light
would begin to flicker after about a half hour of driving.  He said
the pressure was a bit low but it was an older car so that was to be
expected and to just add a thicker oil and drive it. (The car is a gas

My sons 1987 Cabriolet keeps losing the lower belt; the one that drives the
P.S. pump and water pump. I've checked the alignment of the pulleys, and
have swapped out all the pulleys (crank, W.P. and P.S. pump) with good
condition spares that I had. I've even replaced the water ...

How can I tell what my engine code is ?
The car is a 2002 Passat GLS 1.8T with 5 speed stick.
I wish to replace my ignition coils with the Hitachi model from ECS
http://www.ecstuning.com/stage/edpd/pagebuild_v2.cgi?make=Volkswagen&engine=1 ...

My wife likes the size and handling of a Rabbit but I'm unimpressed with the
fuel economy and reliability reports over the last decade.  I don't see the
sense of VW's entry-level economy car having a 2.5L engine.  Has VW decided
to ignore my demographic (way over 45 and concerned ...