Anyone have ideas on how to stop this?
So far I've: Adjusted the valves, put in a new gasket, took off the
cover and put sealer on the gasket.
If anything it now leaks worse.

I want to replace my o2 sensor on my 84 Rabbit.  But I can't figure out an
easy way to get to it.. I am trying to come at it from under the intake
manifold, from the driver's side, after removing the intake from the
throttle body, and some kind of metallic heater hose.  But I ...

  Wondering if this is something i need to fix or just get it
repainted or what now.
  The a 3 inch section of the track that is used to jackup the car on
my golf is bent inwards and some of the paint is coming off.  I dunno

ok. I am a stumped by a 2005 jetta ignition. The key will not enter
the cylinder.  There is a slide visible in the keyway, usually this is
the switch for the "key is in the ignition" chime. The slide appears
to be getting stuck. I can't imagine this is the first time this has

I have a small hole in the exhaust manifold right where it attaches to the
engine -- actually a small piece of the gasket is missing. There's a little
space in there that would seem ideally suited to accept a dollop of foam.
The foaming insulation at  the hardware store can only ...

We've been working for a couple of months off and on on a 1987 Jetta
GL 1.8 8-valve gas that refuses to run. I inherited in from a guy who
told me he drove it for a while and then developed a head gasket leak,
so he took the head off and had it surfaced, reinstalled it, and was

Anyone have a link for instructions on how to install/align a 5-spd A1 shift
kit? Or help me with installation.  I installed the kit, everything not just
bushings and shift rods, the whole shebang.  But, still cant get into
reverse or 5th.  I tried aligning the shifter base, no ...

…With this water fuel technology, I have personally saved more than
50% in fuel costs savings ever since I started using this system…
http://tbmcars.googlepages.com/car_running_on_water_is_water_4_gas_scam

VW Passat Estate 1800CL 1985
I took the head off and had it skimmed, adjusted the valve clearences with
new shims and reassembled the engine. It starts but runs so 'lumpy' it shakes
the driver when ticking over. It isnt misfiring and it isnt slow to rev up.

Hiya,
I have a 1998 1.6 CL Golf MkIII that has a strange occasional cutting out
fault that's got me stumped. Engine is an AFT.
The engine will occasionally just cut out on me, just dies, no

I replace the gearbox drive shaft oil seal on my
G2 16v yesterday,
everything smooth except the followings:
After removing the drive flange from the gearbox,

Hello group,
Sorry about the length of this post but I hope someone has the time to
read it all!
Our family Mk3 Golf 1.8CL estate (ADZ engine) has developed a misfire

At the last MOT of my 2000 2.0 Cabrio, I had a warning that the top steering
mounts were showing signs of play.  I'm now getting a knocking from the
steering when turning from lock to lock and at low speeds.  The car had a
new steering rack 20k ago, so I'd like to think it's not ...

Anyone heard of a seven seat conversion kit for Passat Estates03 ??
Tks

Check engine light after auto -> manual tranny swap
That's the problem, it can be reset, but only stays reset
as little as 5 miles and we need it to pass emissions.
1996 Jetta Trek. Early days of computers for Jetta I guess.